Table of Contents
Advertisement
• ON/OFF
Switch - Ensure switch func-
tions p roperly bymoving theswitch to
theOFF position. Make suremotor
stops; then restart motor and continue.
• Inlet Cover - Discontinue
use ofunit i f
inlet cover fails t olatch p roperly
orifitis
damaged
inany way.
AFTER EACH
USE
INSPECT AND CLEAN UNIT & LABELS
Stop unit and unplug extension
cord.
• After each use, inspect complete
unit
for loose or damaged
parts. Clean the
unit using a damp cloth.
• Wipe off unit with a clean dry cloth.
CLEAN
COLLECTION
BAG
IMPORTANT:
THE COLLECTION
BAG
MUST BE PROPERLY EMPTIED.
• You must properly empty and maintain
the collection bag to avoid deterioration
and obstruction of air flow.
• Remove the collection bag from the unit
and empty after each use. Do not store
bag without emptying the bag of all con-
tents (grass, leaves, etc.).
• Wash the bag once a year. Remove the
bag from the blower and turn the bag in-
side out. Wash the bag with a water
hose. Allow the bag to hang and dry
completely
before you reuse the bag.
HOW TO REMOVE
AN OBJECT
FROM THE AIR INTAKE
_WARNING:
Stop the unit and dis-
connect
from the power source
before
opening the inlet cover. The motor must
be stopped
and the impeller
blades no
longer
turning
to avoid serious
injury
from the rotating blades.
1. While holding the inlet cover open,
remove the vacuum
tubes. The inlet
cover must be held open through all
remaining
steps.
2. Carefully
reach
into
the vacuum
opening and clear out the air intake
area. Clear all debris from impeller.
3. Inspect
the impeller
for cracks.
If
cracked or damaged,
do not use the
unit. Have parts replaced by your au-
thorized
service
dealer.
Do not at-
tempt to replace them yourself.
,,%
WARNING:
Perform the following
steps after each use:
• Stop unit and disconnect from the pow-
er source.
• Allow motor to cool before storing or
transporting.
• Store unit with all guards in place. Posi-
tion unit so that any sharp object cannot
accidentally
cause injury.
• Store unit unplugged,
well out of the
reach of children.
SEASONAL
STORAGE
Prepare unit for storage at the end of
the season
or if it will not be used for
30 days or more.
If your blower is to be stored for a period
of time:
• Stop unit and disconnect from the pow-
er source.
• Clean the entire unit before lengthy stor-
age.
• Open inlet cover and clean any dirt,
grass, or debris that has collected.
In-
spect the blower and all tubes. Close
and make sure the cover is latched.
• Clean air vents and air inlet of debris.
• Store your unit and extension cord in a
well ventilated area and covered, if pos-
sible, to prevent dust and dirt accumula-
tion. Do not cover with plastic. Plastic
cannot
breathe and may cause con-
densation
and eventual
rust or corro-
sion.
• Check entire unit for loose screws. Re-
place any damaged,
worn, or broken
parts.
lO
Advertisement
Table of Contents
