Table of Contents
Advertisement
•
To readjust the control cable, loosen the hexjam
nut on the auger control cable "Z" fitting.
•
Rotate the coupling end of the cable
counterclockwise
to provide more slack.
•
Retighten the hex jam nut. See Figure 1.
•
Repeat Auger Control Test to verify proper
adjustment has been achieved.
Figure 1
ChuteClean-Out T ool
The chute clean-out tool is conveniently fastened to the
rear of the auger housing with a mounting clip. Should
snow and ice become lodged in the chute assembly
during operation, proceed as follows to safely clean the
chute assembly and chute opening:
•
Release both the Auger Control and the Drive
Control.
•
Stop the engine by removing the ignition key.
•
Remove the clean-out tool from the clip which
secures it to the rear of the auger housing.
•
Use the shovel-shaped
end of the clean-out tool to
dislodge and scoop any snow and ice which has
formed in and near the chute assembly.
,_
WARNING:
Never use your hands to clean
snow and ice from the chute assembly
or
auger housing
•
Refasten the clean-out tool to the mounting clip on
the rear of the auger housing, reinsert the ignition
key and start the snow thrower's engine.
•
While standing in the operator's position (behind
the snow thrower), engage the auger control for a
few seconds to clear any remaining snow and ice
from the chute assembly.
Operating Tips
NOTE:
Allow the engine to warm up for a few minutes
after starting. The engine will not develop full power
until it reaches operating temperature.
,_
WARNING:
The
muffler,
engine
and
surrounding
areas
become
hot and
can
cause a burn. Do not touch.
•
Discharge snow downwind whenever possible.
•
Slightly overlap each previous swath.
•
Set the skid shoes 1/4" below the scraper bar for
normal usage. The skid shoes may be adjusted
upward for hard-packed snow. Adjust downward
when using on gravel or crushed rock.
•
Avoid possible starter freeze-up. Clean the snow
thrower thoroughly after each use.
12
Hide quick links:
Advertisement
Table of Contents
