Table of Contents
Advertisement
Available languages
Available languages
Drain facility
The recommended
height of the standpipe
is 18 in/46 cm. The drain hose must be routed
through
the drain hose clip to the standpipe.
The standpipe
must be large enough to accept
the
outside
diameter
of the drain hose. The drain hose is attached
at the factory.
Flooring
For best performance,
you must install your washer
on a solidly constructed
floor. Wood
floors
may need to be reinforced
to minimize vibration
and/or unbalanced
load situations.
Carpeting
and soft tile surfaces
are contributing
factors to vibration
which can cause your washer to move
slightly during the spin cycle.
Never install your washer
on a platform
or weakly supported
structure.
Location considerations
Do not install your washer
in areas where water may freeze, since your washer will always retain
some water in its water valve, pump, and hose areas. Freezing water can damage
the belts,the
pump,
hoses and other components.
Alcove or closet installation
MINIMUM CLEARANCES
FOR CLOSET AND ALCOVE INSTALLATIONS:
Sides - 1 in / 25 mm
Top - 17 in / 432 mm
Rear - 5.9 in / 150 mm
Closet Front - 2 in / 51 mm
If the washer
and dryer are installed together,
the closet front must have at least a 72 in2 (465
cm 2) unobstructed
air opening.
Your washer
alone does not require a specific
air opening.
A. Recessed
area
B. Side view - closet
or confined
area
_A
1 in.
(2.5 cm)
rq
.....
rH3--
1in, -_1_: -
27in, _
_
27in, _ff_,:-
l in.
\
(2,5cm)
(68.6cm)
(68.6cm)
(2.5crn)
B
17in.
(43.2 c m)
2 in, -_l,_t_
32,3 in, _p_-5,9
in.
,,. (5 crn)
(82.0crn)
(15.0cm)
Undercounter
installation (washer only)
i .iF
F
(101.6cm)
_
lin.-_l_-'_
27in. _]_-lin.
(2.5 crn)
(68,6 c rn)
(2.5 crn)
Installing
your washer
15
WF405ATPA-03145A-01
EN.indd
Sec2:15
2012-03-08
gfl4:39:06
Advertisement
Table of Contents
