Drain facility
If you use a standpipe, the recommended height of the standpipe is 18 in (46 cm). The drain hose
must be routed through the drain hose clip to the standpipe. The standpipe must be large enough to
accept the outside diameter of the drain hose. The drain hose is attached the factory.
Flooring
For best performance, your washer must be installed on a solidly constructed floor. Wood floors
may need to be reinforced to minimize vibration and/or unbalanced load situations. Carpeting
and soft tile surfaces are contributing factors to vibration which can cause your washer to move
slightly during the spin cycle.
Never install your washer on a platform or weakly supported structure.
cauTion
Location considerations
Do not install your washer in areas where water may freeze, since your washer will always retain
some water in its water valve, pump, and hose areas. Frozen water can cause damage to the
pump, hoses, and other components.
Alcove or closet installation (washer only)
MINIMUM CLEARANCES FOR CLOSET AND ALCOVE INSTALLATIONS:
Sides - 1 In. (2.5 cm)
Rear - 5.9 In. (15 cm)
If the washer and a dryer are installed together, the closet front must have at least a 72 in²
(465 cm²) unobstructed air opening. Your washer alone does not require a specific air opening.
1 in.
(2.5 cm)
A. Recessed area
B. Side view - closet or confined area
Undercounter installation (washer only)
WF36J4000AW-02832L_EN.indd 13
Top - 17 In. (43.2 cm)
Closet Front - 2 In. (5.1 cm)
a
1 in.
(2.5 cm)
27 in.
27 in.
(68.6 cm)
(68.6 cm)
39 in.
(99 cm)
1 in.
(2.5 cm)
b
1 in.
2 in.
(2.5 cm)
(5 cm)
27 in.
(68.6 cm)
(2.5 cm)
English _13
17 in.
(43.2 cm)
31,5 in.
5.9 in.
(80 cm)
(15 cm)
1 in.
2015/4/20 9:34:10