Maintaining; Cleaning The Cabinet; Care And Handling Of Discs; Troubleshooting - Insignia NS-LDVD19Q-10A - 19" LCD TV User Manual

Maintaining

Cleaning the cabinet

Wipe the front panel and other exterior surfaces of
your TV/DVD combo with a soft cloth lightly
dampened with lukewarm water. Never use a
solvent or alcohol to clean your TV/DVD combo. Do
not spray insecticide near your TV/DVD combo.
Such chemicals may cause damage and
discoloration to the exposed surfaces.

Care and handling of discs

Handling discs
Do not touch the playback side of the disc. Hold the
disc by the edges so that fingerprints do not get on
the surface. Never stick paper or tape on the disc.
Storing discs
After playing, store the disc in its case. Do not
expose the disc to direct sunlight or sources of heat,
and never leave it in a parked car exposed to direct
sunlight.
Cleaning discs
Fingerprints and dust on the disc can cause poor
picture quality and sound distortion. Before
playing, clean the disc with a clean cloth. Wipe the
disc from the center out.
Do not use strong solvents such as alcohol, benzine,
thinner, commercially available cleaners, or
anti-static spray intended for older vinyl records.
Note
Never operate your TV/DVD combo immediately
after moving it from a cold location to a warm
location. Leave it for two or three hours without
operating it. If you use your TV/DVD combo in such a
situation, it may damage discs or internal parts.

Troubleshooting

TV
Problem Solution
No picture or sound • Check all cable connections.
• Make sure that your TV/DVD combo is turned on.
Picture is OK, but no • Check the volume level and mute setting.
sound
Sound is OK, but no • Check the color control and adjust it.
color • Check the program's color features because it may be
a black and white movie.
Problem
The picture has
overlapped images
Picture has snow
Stripes on picture
Bad stereo or SAP
sound
Remote control does
not work
"Unsupported Mode"
appears on the screen
"No Signal" appears on
the screen
Image is not clear
Image is not centered
Picture has a few bright
or dark dots

DVD player

Problem
No sound
No image
Bad sound quality
Disc cannot be played
The player does not
operate normally
Remote control does
not work
www.insigniaproducts.com
Solution
• Make sure that the antenna is installed correctly. If
not, adjust the antenna towards the broadcasting
station.
• Check the antenna and its connection. If there are
problems, correct them. If all connections are tight,
the problem may be with a faulty antenna or cable.
• Check car traffic or neon signs that may disrupt the
image.
• Check for interference from other electronic devices,
such as radios and televisions, and keep magnetic or
electronic devices away from your TV/DVD combo.
• A long broadcast distance or interference from radio
waves can cause bad sound reception. Try changing
the mode to Mono.
• Remove obstacles between the remote control and
the remote control sensor on the front of your
TV/DVD combo.
• Point the remote control at your TV/DVD combo's
remote control sensor.
• Install fresh batteries.
• Check the resolution and frequency of your computer,
and adjust it to the optimum resolution for your
TV/DVD combo: 1360 × 768 at 60 Hz.
• Make sure that the cable is firmly connected to the
computer and TV/DVD combo.
• Adjust the phase control.
• Adjust the horizontal control.
• A few bright or dark dots on an LCD screen are
normal. It does not affect the operation of your
TV/DVD combo.
Solution
• Make sure that your TV/DVD combo or amplifier is
working correctly.
• Make sure that the amplifier is set to receive DVD
signal input.
• Make sure that your TV/DVD combo is working
correctly.
• Make sure that the color system is set correctly.
• Make sure that the audio output mode is set correctly.
• Make sure that the audio connection between your
TV/DVD combo and amplifier (if used) is secure.
• Make sure that the disc is inserted with the label
facing forward.
• Clean the disc.
• Moisture may have condensed in the DVD player.
Remove the disc and leave the player on for about an
hour to dry out.
• Disconnect the power plug, then reconnect it.
• Remove obstacles between the remote control and
the player.
• Point the remote control at your TV/DVD combo's
remote control sensor.
• Install fresh batteries.
43