Filling Oil Tank - Remington POLE SAW 8FT Manual

SAW CHA!N
TENSION
ADJUSTMENT
Continued
FILLING
OIL TANK
097017
Figure 6 - Turning Adjusting Screw
Guide Bar
Nuts
incorrect Tension
Figure 7 - Saw Chain Adjustment
Correct Tension
1. Remove oil cap.
2. Fill oil tank with SAE #30 motor oil. Note:For temperatures below 30°F, use
SAE #10 oil. For tem_mtures above 75°F, use SAE #40 oil.
3. Replace oil cap at once. Tighten oil cap firmly for good seal. This will avoid oil
seepage from tank.
4. Wipe offexcess oil.
Note: It is normal for oil to seep when saw is not in use. Empty oil tank after each
use to prevent seepage. _1_