Table of Contents
Advertisement
OPERATING
CHAIN SAW
Continued
Log Supported
On One End
1. Make first cut on underside of log (see Figure 16). Use top of guide bar to make
this cut. Cut I/3 through diameter
of log. This cut will keep section from
splintering
when cut.
2. Make second cut directly above first cut. Cut down to meet first cut. This cut
will keep log from pinching guide bar and chain.
2nd Cut
1st Cut
Figure 16 - Bucking Log When Log Is Supported On One End
Log Supported
On Both Ends
1. Make first cut from above log (see Figure 17). Cut 1/3 through diameter of log.
This cut will keep section from splintering
when cut.
2. Make second cut on underside
of log, directly under first cut. Use top of guide
bar to make this cut. Cut up to meet first cut. This will keep log from pinching
guide bar and chain.
t
s..
,_lz. _
,_
_
1st Cut
!
-
2nd Cut
Figure 17- Bucking
Log When Log Is Supported On Both Ends
097017
Hide quick links:
Advertisement
Table of Contents
