Table of Contents
Advertisement
inspect and properly tighten all parts of the exercise
cycle regularly, The exercise cycle can be cleaned
with a soft, damp cloth, To prevent damage to the
consob, keep liquids away from the consob and keep
the consob out of direct sunlight,
TIGHTENING
THE PEDALS
For best performance, regularly tighten both pedals,
CONSOLETROUBLESHOOTING
if the consob display becomes dim, the batteries
should be replaced, See assembly step 4 on page 5
for replacement instructions, if the consob does not
display your heart rate when you use the handgrip
pube sensor, see step 5 on page 13,
HOW TO LEVEL THE EXERCISE CYCLE
if the exercise
cycle does not sit
fiat on the floor,
turn one or both
of the leveling
pads until the
exercise cycle is
level,
Leveling
Pads
HOW TO ADJUST THE REED SWITCH
if the console does not display correct feedback, the
reed switch should be adjusted, To adjust the reed
switch, remove the indicated M4 x 48mm Screws (20)
and M4 x 16mm Screws (21) from the Left Side
Shield (4), Using an adjustable wrench, turn the Left
Pedal (40) clockwise and remove it, Turn the left side
19
21
of the Crank (19) so that it is pointing toward the front
of the exercise cycle, and then slide off the Left Side
Shield,
Locate the
Reed Switch
(44), Turn the
Crank (19)
until the
Magnet (54) is
aligned with
the Reed
Switch,
Loosen, but
do not
indicated M4
_
\
44
x 16mm Screw (21), Slide the Reed Switch slightly
closer to or away from the Magnet, Then, retighten
the Screw, Turn the Left Crank Arm for a moment,
Repeat until the console displays correct feedback,
When the Reed Switch is correctly adjusted, reattach
the left side shield and the left pedal,
HOW TO ADJUST THE DRIVE BELT
if you can feel the pedals slip while you are pedaling,
even when the resistance is at the highest level, the
Drive Belt (64) may need to be adjusted, See HOW
TO ADJUST THE REED SWITCH at the left, To adjust
the Drive Belt, the Right Side Shield (5) must first be
removed, Remove the indicated M4 x 48mm Screws
(20) from the Left Side Shield (4) and the M4 x 16mm
Screws (not shown) from the Right Side Shield, Using
an adjustable wrench, turn the Right Pedal (not
shown) counterclockwise
and remove it, Next, turn the
right side of the Crank (19) so that it is pointing
toward the front of the exercise cycle, and then slide
off the Right Side Shield,
Next, turn the
indicated M8 x
35mm Screw
(72) until the
Drive Belt (64)
is properly
tightened,
Then, reattach
the right side
shield and the
right pedal,
2O
Hide quick links:
Advertisement
Table of Contents
