Table of Contents
Advertisement
ovD vc_z AuxSa_C_BLE
&&°&&
You'll use these buttons when you program
the remote to operate another component.
The remote may not operate all models of
all brands.
Programming the Remote to Operate
Other Components
The universal
remote
control
can be programmed
to operate
most
brands
of
remote
controllable
VCRs, satellite
receivers
and cable
boxes.
The remote
is
already
programmed
to operate
most
RCA, GE and Proscan
TVs, VCRs, DVD
players,
laserdisc
players
and satellite
receivers.
Find Out If You Need to Program the Remote
To determine
whether
the universal
remote
needs
to be programmed,
turn a
component
ON, such as a VCR, point
the remote
at the VCR, and press
the
VCR1 button.
Then
press
ON-OFF
or channel
up or channel
down
to see if
the VCR responds
to the remote
commands.
If not, the remote
needs
to be
programmed.
How to Program the Remote
There
are two ways
to program
the remote
control:
automatic
code
search
and
direct
entry.
Instructions
for both ways
follow.
Tostop the automatic code searchwithout
programming any components,pressand hold CLEAR
until the light on the remote turns off.
Using Automatic
Code Search
1.
Turn
on the component
you want
the remote
to operate
(VCR, satellite
receiver,
etc.).
2.
.
.
Press and hold
the component
button
on the remote
control
that
corresponds
to the component
you want
the remote
to operate
(VCR1,
VCR2, etc.). While
you hold down
the component
button,
press
and hold
ON-OFF
(when
the red light on the remote
turns
on, release
both
buttons).
Press PLAY (the red light on the remote, located below the ON-OFF
button,
starts flashing).
The remote is searching
the first set of component
codes (there are 20 sets
of codes). If the component
you want to operate doesn't turn off"
automatically
after 5 seconds, press PLAY again (the red light starts flashing
again as the remote searches
through the next set of codes).
Continue
pressing
PLAY until the component
turns
off.
]Vote: I£ the component
doesn't
turn
o!_£after you've
pressed
the PLAY
button
20 times,
the component
can't
be progTammed,
Press REVERSE, wait 2 seconds.
Repeat
this step until the component
turns
back on.
5.
To finish, press and hold the STOP button until the red light on the remote
turns off'.
18
Chapter
2
Advertisement
Table of Contents
