Table of Contents
Advertisement
Startup
.
Set the
Signal
Type.
The first step in programming your TV/VCR is to select the signal source.
A. Press MENU on the remote to display the main menu. Then press CH • or •
until Setup is highlighted. Press VOL+ or - to display the Setup menu.
B.
From the Setup menu, using the VOL- or VOL+ buttons, select Antenna if
your TV/VCR is connected to an antenna, or, depending on what type of
cable you have, select Cable STD, Cable HRC or Cable IRC. If you are not
sure what type of cable system you have, contact your cable company.
Time Set
Timer Record
Setup
Air/Cable
Antenna
Auto
Program
Add/Erase
Added
Sleep
Off
I Language ....................
...........................................
_:Adjust
Bi_:Move
ITFI:Menu
7.
Program
the
channels
into
memory
(Auto
Program).
In order to automatically program channels into the TV/VCR's memory, you
must have already selected the signal source (see step 6), and the antenna or
cable system must be connected to the TV/VCR.
A. Press MENU on the remote to display the main menu. Then press the CH•
or• button until Setup is highlighted. Press VOL+to display the Setup menu.
B. From the Setup menu, press CH• until Auto Program is highlighted.
C.
Press the VOL+ or - button to begin programming channels into memory. The
TV/VCR places available channels in its memory. This may take a couple
minutes. Press MENU if you want to interrupt this process and return to
normal viewing. When the process is complete, press CH • or • to scan your
newly programmed channels.
Video
Time Set
Setup
VCR Setup
[Setup
/ Air/Cable
Antenna
/
/ Auto Program
| Add/Erase
Added
/ Sleep
Off
Language
English
4
Advertisement
Table of Contents
