RCA F32730 Owner's Manual page 46

Set VCR 2 Channel Displays a ChOice list that lets you select •
the channel that the TV tunes to when you press the VCR2.LD
button.
The choices are the same as those listed under Set VCR 1
Channel, above, except that the component is the Second VCR
or laserdisc player, and the remote button being programmed
is VCR2oLD. For example:
Video 2 Input Choose •this if your second VCR or laserdisc
player is connected to the Video 2 jacks on the back of the
TV and you want the TV to tune to Video 2 input when
you press the VCR2-LD button. This is a typical setting for
a second VCR or laserdisc player.
Set DSSeCable Channel Displays a choice list that lets you
select the channel that the TV tunes to whenyou press_the
DSS-CABLE button. Usually, DSSoCABLE can control either a
DSS receiver connected to the Video 1 input jacks, or a cable
box connected to the Antenna A jack.
The choices are the same as those listed under Set VCR i
Channel, above, except that the component is either a DSS
Receiver or a cable box, and the button being programmed is
DSSoCABLE. Here is an example for each:
Video 1 Input Choose this if your DSS Receiver is
connected to the Video 1 jacks on the back of the TV and
you want the TV to tune to Video 1 input when you press
the DSSeCABLE button. (This is the typical setting for a
DSS Receiver.)
Ch 3 Antenna A Choose this if your Cable box is
connected to the Antenna A jack on the back of the TV
and you want the TV to tune to channel 3 when you press
the DSSoCABLE button. (This is a typical setting for a
cable box.)
• Video 1 Input Source Displays choice list thatlets you tell"
the TV whether your Video 1 input source is connected with a
regular video cable or both an S-Video cable and a video
cable.
44
r.
• iii i
Important
if you are using an S-Video
connection, make sure to change
the Video 1 Input Source to S-
Video. If you don't, the TV won't
know to tune to the S-Video
channel.