Table of Contents
Advertisement
STEP 1: UNPACK
THE TV
Make sure to locate the remote control,
STEP 2: CONNECTING
YOUR
TV
There are three types of connections
outlined
in this section:
TV Only:
If you're only going to connect the
TV to your home antenna or cable
system.
The Basic Connection:
If you're going to connect the TV to a
VCR or satellite
receiver.
Advanced
Connections:
If you're
going to make multiple
connections,
hooking
up the TV to
one or two VCRs, DVD player, and a
satellite
receiver.
Cable information
and illustrations
are given for each type of connection.
Once you have completed
your desired connection
you may skip forward
to Step 3.
TV ONLY
This is a basic connection
from an antenna
or cable system to your TV.
Connect the cable into the Cable/Antenna
jack as shown.
f
Important
Stand
Information
Direct View TVs: 27"- 36" diagonal
CAUTION: Choose the location
for your TV
carefully. Take precautions that the stand
or other furniture the TV is placed on is
properly located (see Important
Safeguards sheet) and of adequate size
and strength to prevent the TV from
accidentally being tipped over, pushed off,
or pulled off. This could cause damage to
the TV and/or personal injury.
j
rBefore
You Connect
Protect against power surges:
• Connect all components before
plugging any power cords into the wall
outlet.
• Turn off the TV and/or component
before connecting or disconnecting any
cables.
i
• Make sure all antennas and cables are
properly grounded. Refer to the Safety
Tips sheet packed with your TV.
Cables
You will use the following cable to make your connection:
Coaxial
Cable: These cables carry audio and video
signal to the TV from an antenna, cable, or cable
box,
CABLE, CABLE BOX, OR ANTENNA
INPUT 2
Once you have completed
this connection
go to "Step 3:
Connecting
the IR Controller"
on page 9.
4
Advertisement
Table of Contents
