Table of Contents
Advertisement
PROGRAMMING
TH E REMOTE
The universal
remote can be programmed
to control
most brands of
remote controllable
VCRs, satellite
receivers and cable boxes. The
remote is already programmed
to control
most RCA, GE and PROSCAN
TVs, VCRs, DVD players, laserdisc players and satellite
receivers.
TESTING
THE
REMOTE
To determine
whether
the universal remote needs to be programmed,
turn a devic e ON, such as a VCR, point the remote at the VCR, and press
the VCR1 button.
Then press ON.OFF or CH + (channel up) or CH *
(channel down) to see if the VCR responds to the remote commands.
If
not, the remote needs to be programmed.
PROGRAMMING
THE
REMOTE
Using Automatic
Code Search
The following instructions can be used to program
the remote to
control each of the devices connected to your "IV. If you want to exit the
automatic code search without
programming
any of your devices, press
and hold CLEAR until the LED turns off.
1.
Turn on the device you want to control (VCR, SAT, etc.).
2_
Press and hold the button
you want to program (VCR1, VCR2, etc.).
Note that the AUX button
can only be programmed
using direct
code entry. (See the next section for details,) While holding
the
device button,
press and hold ON.OFF until the red light on the
remote turns on, then release both buttons.
3.
Point the remote at the device, press and release PLAY, then wait
five seconds or until the LED stops flashing.
At this point the remote
is searching for the correct code to
program.
If, after five seconds, the device you want to control does
not turn off, press PLAY again to tell the remote to search the next
set of codes.
Continue
pressing PLAY until the device turns off or you have
searched through
all of the codes. There are 20 total sets of codes.
If the device does not turn off after pressing PLAY 20 times, then
the remote cannot control
that particular
device.
If the device you want to control
does turn off:
1.
Press and release REVERSE,then wait two seconds. Repeat this
step until the device turns back ON.
2.
To finish, press and hold STOP until the red light on the remote
turns off.
STC_
You'll use these buttons when you
program the remote to control any
device.
The remote may not operate all models
of all brands.
24
Advertisement
Table of Contents
