Transmitter/Receiver Throughput Connections - Extron electronics VERSATOOLS MTP User Manual

Installation, cont'd
When making connections for the MTP from existing
audio cables, see figure 2-14 to identify the tip, ring, and
sleeve wires in various connectors. A mono audio
connector consists of the tip and sleeve. A stereo audio
connector consists of the tip, ring and sleeve. The ring,
tip, and sleeve wires are also shown on the captive screw
audio connector diagrams, figure 2-13 and figure 2-21.
Tip (+)
Sleeve ( )
RCA Connector (Mono)
Figure 2-14 — Typical audio connectors
Audio input RCA connectors (RCA and AAP models) —
4
Connect an unbalanced stereo audio source to these L(eft) and
R(ight) RCA connectors (figure 2-15).
Tip (Signal)
Sleeve (Gnd )
Figure 2-15 — RCA audio connectors
VersaTools ® MTP Series • Installation
2-14
Tip (L)
Ring (R)
Sleeve ( )
3.5 mm Stereo Plug Connector
(unbalanced)
Right Channel
(Red Jacket)
Left Channel
(White Jacket)

Transmitter/receiver throughput connections

See figure 2-16 to identify the connections between the
transmitter and receiver.
MTP Transmitters
INPUT
L R
S-VIDEO OUTPUT
12V
0.5a MAX
MTP T SV A RCA
5
INPUT
L R
VIDEO OUTPUT
12V
0.5a MAX
MTP T AV
Figure 2-16 — Throughput connections
CAUTION Do not connect these devices to a computer data or
telecommunications network.
RJ-45 termination must comply with the
TIA/EIA T 568A or TIA/EIA T 568B wiring standards
for all connections.
Transmitter output and receiver input connector — Connect
5
one end of a TP cable to this RJ-45 female connector on the
transmitter. On the MTP T SV A AAP and MTP T AV AAP, the
connector is at the end of a short pigtail.
Connect the free end of the same TP cable from the transmitter
to this RJ-45 female connector on the receiver.
®
VersaTools
MTP Receivers
OUTPUT
L R
S-VIDEO
INPUT
12V
0.5a MAX
MTP R SV A RCA
5
OUTPUT
L R
VIDEO
INPUT
12V
0.5a MAX
MTP R AV
5
MTP Series • Installation 2-15