Table of Contents
Advertisement
Trouble Checks
Trouble
Checks
and Adjustments
VC_____KR
Can't record one channel
with the VCR while
watchi_g
a different
channel
on the TV
For connections
4B, 5B:
1. Turn on TV, VCR, satellite receiver, and cable box (if required).
2. Make sure IRD/TV switch on satellite receiver is in TV position
so signal
from cable box or antenna
is coming out the OUT TO TV jack on the
satellite receiver.
3. If cable box is required,
use CHANNEL buttor_s on VCR to tune VCR to
output channel of cable box (usually 02, 03, or 04).
4. Select channel 03 or 04 on TV (depending
on the position
of the
GH3/CH4 switch on the back of the VCR).
5. Select desired channel with CHANNEL buttons
on cable box if cable box
is required.
If cable box is not required,
seled desired channel with
CHANNEL buttons
on VCR.
6. Insert tape in VCR and press RECORD
on VCR.
7. To watch satellite channel,
select channel
00 on TV.
8. Then select desired channel to watch with CHANNEL buttons
on
satellite receiver.
For connections
4C, 5C:
1. Turn on TV and select channel 00 on TV with remote.
2. Turn on satellite receiver and select desired sateTLlitechannel with
CHANNEL buttons on satellite receiver.
3. Turn on VCR and set it to line mode (see glossar.¢) so youcan
see the
satellite signal coming into its AUDIONIDEO
IN jacks.
4. Insert tape in VCR and press RECORD
on VCR
5. Press "I'V/VCRbutton on VCR. This lets the cable signal flow directly
out of the OUT TO IV jack of the VCR without affecting the recording.
6. If cable box is required,
turn on cable box, change channel on TV to
output channel of cable box (usually 02, 03, or 04), and select desired
channel with CHANNEL buttons on cable box.
7. If cable box is not required,
select desired channel with CHANNEL
buttons
on TV.
continued on _.henext page
25
Advertisement
Table of Contents
