TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked
on level ground or driveway. Make sure
tires are properly inflated (See =PROD-
UCT SPECIFICATIONS" section of this
manual). If tires are over or
undednflated, you will not properly adjust
your mower.
SIDE-TO-SIDE ADJUSTMENT
• Raise mower to its highest position.
• At the midpoint of both sides of mower,
measure height from bottom edge of
mower to ground. Distance "A" on
both sides of mower should be the
same or within 1/4" of each other.
• If adjustment is necessary, make
adjustment on one side of mower only.
• To raise one side of mower, tighten lift
link adjustment nut on that side.
• To lower one side of mower, loosen lift
link adjustment nut on that side.
NOTE:
Each full turn of adjustment nut
will change mower height about 1/8".
• Recheck measurements after adjust-
ing.
Bottom edge of
Bottom edge of
mower to ground
mower to ground
• Before making any necessary adjust-
ments, check that both front links are
equal in length.
• If links are not equal in length, adjust
one link to same length as other link.
• To lower front of mower loosen nut "E"
on both front links an equal number of
turns.
• When distance =D" is 1/8" to 1/2" lower
at front than rear, tighten nuts "F"
against trunnion on both front links.
• To raise front of mower, loosen nut "F"
from trunnion on both front links.
Tighten nut =E"on both front links an
equal number of tums. The two front
links must remain equal in length.
• When distance =D" is 1/8" to 1/2 =lower
at front than rear, tighten nut =F"against
trunnion on both front links.
• Recheck side-to-side adjustment.
"D"
Both Front Unks Should be Equal in Length
Suspension Arm
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-to
side. if the following front-to-back
adjustment is necessary, be sure to
adjust both front links equally so mower
will stay level side-to-side.
To obtain the best cutting results, the
mower housing should be adjusted so
that the front is approximately 1/8" to 112"
lower than the rear when the mower is in
its highest position.
Check adjustment on right side of tractor.
Measure distance =D _ directly in front
and behind the mandrel at bottom edge
of mower housing as shown.
:=E"
Front Links
TO REPLACE
MOWER
BLADE DRIVE
BELT
The mower blade drive belt may be
replaced without tools. Park the tractor on
level surface.
Engage parking brake.
BELT REMOVAL-
1.
Place attachment clutch in =DISEN-
GAGED"
position.
2.
Move attachment
lift lever forward
to
lower mower to its lowest position.
21