Table of Contents
Advertisement
•
VCR ejects cassette when the end of the tape is reached during a timer recording.
•
Check to make sure VCR plus+ setup was completed
correctly.
Internal
clock
shows
incorrect
time
or date
•
Power interruption.
•
Check to make sure the clock is set accurately
(check AM/PM and date).
•
Check Auto DST setting. The clock may have adjusted for daylight-saving
time.
Time
did not adjust
for daylight-saving
time
•
Check to make sure Auto DST feature is turned on.
VCR
makes
noise
when
stopped
•
VCR is removing
tape from heads. This is normal. The head cylinder
inside the VCR will continue to rotate
for a few minutes
after you put the VCR in the stop mode.
Will not Auto
Channel
Search
active
channels
correctly
•
Check to make sure the antenna connections
are secure and correct.
•
Check to make sure the Signal Type: CABLE/ANTENNA
feature is set correctly.
•
If Detect Automatically
was selected for the Signal Type in the AUTO CHANNEL SEARCH menu, try using
either CABLE TV or ANTENNA.
•
May not need to auto channel search if using a cable box. Refer to the VCR Channel List or contact your
cable company
for more information.
Tape
plays
back
in slow
motion
•
Press PLAY to return to normal playback.
Cannot
select
channels
over
69
•
Cable channels over 69 can only be selected if Signal Type: CABLE/ANTENNA
feature is set to CABLE.
Cassette
with safety
tab removed
does
not start
to play automatically
•
Check to make sure the Auto Play ON/OFF feature is set to ON.
TIMER
indicator
flashes
•
Clock is not set.
•
Check to make sure there is a cassette in the VCR when a timer recording
is set.
Time
counter
disappears
during
searching
•
This is normal.
On-screen
menus
appear
in English,
French
or Spanish
•
Check Language feature.
52
Advertisement
Table of Contents
