Troubleshooting 2_0 - Philips Home Theater System User Manual

Main unit
• Power supply:
• Europe/China/Russia/India: 220-240Vm
50 Hz
• Latin America/Asia Pacific: 110127V/220
240Vm 50%0 Hz
• Power consumption: 105 W
• Standby power consumption: _<05 W
• Dimensions (WxHxD): 435 x 56 x 344 mm
• Weight: 3,0kg
Subwoofer
• Output power: 166 W RNS (+/05dB 30%
THD)
• Impedance: 4 ohm
• Speaker drivers: 165 mm (65) woofer
• Dimensions (WxHxD)178 x 303 x 343 mm
• Weight: 39 kg
Speakers
Center speaker:
• Output power: 166 W RNS (+/05dB 30%
THD)
• Speal<erimpedance: 4 ohm
• Speal<erdrivers: 1 x 76,2 mm (3") woofer
• Dimensions (WxHxD): 223 x 101,5 x 93,5 mm
• Weight: 0,6 kg
Front!Rear speaker:
• Output power: 4 x 166 W RiVlS(+/- 0,5dB,
30%THD)
• Speal<erimpedance: 4 ohm
• Speal<erdrivers: 1 x 76,2 mm (3") woofer
• Dimensions (WxHxD):
• Speakers:90 x 185 x 105,5 mm
• Tall speakers:247 x 1091 x 242 mm
• Weight:
• Speakers:0,6 kg/each
• Tall speakers:0,8 kg/each
Remote control batteries
•
2 x AAA..R03..1,5 V
Laser
•
Type: Semiconductor laser GaAIAs (CD)
•
Wave length: 645 665 nm (DVD)770 800
nm (CD)
• Output power: 6 mW (DVD)7 mW (VCD/CD)
• Beam divergence: 60 degrees
2_0 EN
8 Troubleshooting
_ Warning
• Risk of electric shock. Never remove the casing
of the product.
To keep the warranty valid never try to repair the
product yourselfi
If you have problems using this product check the
following points before you request service If you
still have a problem get support at
www philips com/suppol¢
Main unit
The buttons on the home theater do not work.
• Disconnect the home theater fiom the
power supply for a few minutes, then
reconnect
Picture
No picture.
• Make sure that theTV is switched to the
correct source for the home theatel:
• If this happens when you change the
TV system, press _A to open the disc
compartment, and then 439 on the remote
control to restore the defaultTV system,
No picture on a TV connected through HDMI.
• Make sure that the HDIVll cable is not faulty If
it is faulty, replace it with a new cable,
• If this happens when you change the HDMI
video resolution, press _A to open the disc
compartment, and then 304 on the remote
control to restore the default setting,
• Wait for I0 seconds for auto recovery, or
change the HDMI video setting,
Disc does not play high-definition video.
•
Hake sure that the disc contains high-
definition video,
• Make sure that theTV supports high-
definition video,
• Use an HDMI cable to connect to theTX4