Set Up Speakers; Set Up Easylink; Control) - Philips Home Theater System User Manual

Option 2: Connect audio through a digital
coaxial cable
Good quality audio
1 Using a coaxial cable, connect the COAXIAL
connector on your home theater to the
COAXIAL/DIGITAL OUT connector on the
TV or other device,
• The digital coaxial connector might be
labeled DIGITALAUDIO OUT,
DIGITAL IN t
COAXIAL IN
Option 3: Connect audio through analog
audio cables
Basic quality audio
1 Using an analog cable, connect the AUX
connectors on your home theater to the
AUDIO OUT connectors on theTV or other
device,
q
AUX IN / /
AUDIO IN --_ --,
1
L i_- AUDIO 1 VCR
,_ _-OUT
Set up speakers
Set up the speakers manually to experience
customized surround sound,
Before you start
Hake the necessary connections described in the
quick start guide, and then switch theTV to the
correct source for your home theater
1
2
3
Press _ SETUP on your home theater
remote control,
Select [Audio Setup] and then press OK,
Press the Navigation buttons and OK to
select and change:
• [SpeakersVo]ume]: Set the volume level
of each speakel:
• [Speakers Delay]: Set the delay time for
speakers which are placed closer to the
seating position in order to obtain equal
audio transmission fiom all the speakers,
Set up EasyLink (HDMI-CEC
control)
This home theater supports Philips EasyLink,
which uses the HDHI--CEC (Consumer Electronics
Control) protocol, EasyLink-compliant devices that
are connected through HDHI can be controlled
by a single remote control,
• Depending on the manufacturehHDNI-CEC is
known by many names.For insrormationon your
device, see the user manual of the device.
• Philipsdoes not guarantee 100% interoperability
with all HDNFCEC devices.
Before you start
• Connect your home theater to the HDHI-
CEC compliant device through HDHI
connection,
• Hake the necessary connections described in
the quick start guide, and then switch theTV
to the correct source for your home theatel:
EN 9