Advertisement
Available languages
Available languages
9. Operation
Manual for IR wireless
remote controller
9.2. Operation
9.2.1. Turning ON/OFF
[]
[]
i
[]
[]
®
®
©
<To Start Operation>
[] Press the ON/OFF button Q.
o The ON lamp [] and the display area come on.
<To Stop Operation>
[] Press the ON/OFF button Q again.
o The ON lamp [] and the display area go dark.
Note:
Even if you press the ON/OFF button immediately after shutting down the op-
eration is progress, the air conditioner will not start for about three minutes.
This is to prevent the internal components from being damaged.
9.2.2.
Temperature
setting
To decrease the room temperature:
Press (Z) button ® to set the desired temperature.
The selected temperature is displayed [].
I_ To increase the room temperature:
Press C_E) b utton ® to set the desired temperature.
The selected temperature is displayed [].
Available temperature ranges are as follows:
Cooling/Drying:
19 - 30 °C, 67 - 87 °F
Heating:
17-28
°C, 63- 83 °F
Automatic:
19 -28 °C, 67- 83 °F
The display [] flashes either 8 °C - 39 °C, 46 °F - 102 °F to inform you
if the room temperature is lower or higher than the displayed
tempera-
ture. (This display does not appear on the wireless remote controller.)
9.2.3.
Fan speed
setting
[] Press the Fan Speed button @ as many times as necessary while the
system is running.
o Each press changes
the force.
The currently
selected
speed is
shown at [_.
o The change sequence, and the available settings, are as follows.
FAN SPEED
4-speed
+
Auto
3-speed
+
Auto
Display
Speed
1
Speed
2
Speed
3
Speed
4
Auto
r ""
"7
Speed
1
Speed
2
Speed
3
Auto
"'
" --I
9.2.4. Airflow
direction
setting
<To Change the Airflow's
Up/Down
Direction>
[] With the unit running, press the Airflow Up/Down button ® as necessary.
o Each press changes the direction. The current direction is shown at [_.
o The change sequence, and the available settings, are as follows.
Remote
controller
Wired type
(PCA_KA4)
(PKA-HA4)
IR Wireless
remote controller
Display
Swing
Auto
1
2
3
4
5
_7"_'_-'_''_`
"
_\
"
_'
3
Swing
1
2
3
4
9.3 Timer
AL_O STOP
AUTOST/_T
0
Press the _
or _
button (TIMER SET).
Time can be set while the following symbol is blinking.
OFF timer: AQ-O
is blinking.
ON timer: AQ-J
is blinking.
h
min
® Use the _
and _
buttons to set the desired time.
® Cancelling the timer.
To cancel the OFF timer, press the _
button.
To cancel the ON timer, press the _
button.
o It is possible to combine both OFF and ON timers.
o Pressing the (_ ON/OFF button of the remote controller during timer
mode to stop the unit will cancel the timers.
o If the current time has not been set, the timer operation
cannot be
used.
II
9
Advertisement
