Advertisement
Available languages
Available languages
9. Operation
Manual for IR wireless
remote controller
9.1 Parts Names
'Transmission
area
._
'Remote
controller
display)
* For explanation
purposes, all of the items
that appear in the display are shown.
* All items are displayed when the Reset
button is pressed.
( ON/OFF
buttonj_
(Set
Temperature
buttons)
_.. Fan Speed button (Changes fan speed))
-Airflow button (Changes up/down airflow direction S
_'TestRunbutton
9
[!
Transmission
indicator
Timerindicator
.
,)eration areas
)
)
button
button
--('
Minute button
._
(' Set Time button (Sets the time) ._
" Louver button (Changes left/right airflow direction)
)
'Reset
button
II
Note:
When using the IR wireless remote controller, point it towards the receiver on the indoor unit.
m if the IR wireless remote controller is operated within approximately
2 minutes after power is
supplied to the indoor unit, the indoor unit may beep twice as the unit is performing the initial
automatic check.
m The indoor unit beeps to confirm that the signal transmitted
from the IR wireless remote con-
troller has been received. Signals can be received up to approximately
7 meters in a direct
line from the indoor unit in an area 45 ° to the left and right of the unit. However, illumination
such as fluorescent
lights and strong light can affect the ability of the indoor unit to receive
signals.
II! If the operation lamp near the receiver on the indoor unit is blinking, the unit needs to be in-
spected. Consult your dealer for service.
II! Handle the IR wireless remote controller carefully! Do not drop the IR wireless remote con-
troller or subject it to strong shocks. In addition, do not get the IR wireless remote controller
wet or leave it in a location with high humidity.
II! To avoid misplacing the IR wireless remote controller, install the holder included with the IR
wireless remote controller on a wall and be sure to always place the IR wireless remote con-
troller in the holder after use.
Battery
installation/replacernent
1. Remove the top cover, insert 2 AAA batteries,
and then install the top cover.
1
Top cover
2. Press the Reset butto
_,3
1
2 AAA batteries
/
Insert the negative (-)/
end of each batteryl
first.
Install
the bat-I
teries
in the correctl
directions (+,-)!
J
Press the Reset but-I
ton with an object that
has a narrow end.
8
Advertisement
