Table of Contents
Advertisement
[_Important:
_Important:
_Important:
procedure
(Please
see illustration
on the following
page.)
O Connect
the incoming
cable or antenna
to the ANTENNA
IN
terminal
on the VCR.
O Connect
one end of a coaxial ,cable to the ANTENNA
OUT
terminal
on the VCR.
Connect
the other end of the cable to the I_[T-A
terminal
on the TV.
Connect
an RCA pin-type
video cable to the VIDEO OUT termi-
nal on the back of the VCR.
Connect
the other end of this cable
to the VIDEO
INPUT
terminal
on the back of the television.
If you are connecting
a Super VHS (S-VHS) VCR, use a Super Video
cable instead
of an RCA pin-type
video cable.
Connect
a Super
Video cable to the S-VIDEO
OUT terminal
on the VCR.
Connect
the other end of this cable to the S-VIDEO
INPUT
terminal
on the
back of the television.
Connect
a set of RCA pin-type
audio cables
to the AUDIO OUT
terminals
on the back of the VCR. Use the red cable to connect
the right (R) channel
and the white cable to connect
the i[eft (L)
channel.
Connect
the other ends of this cable to the AUDIO INPUT
terminals
on the back of the television.
If your VCR is monaural
(non-stereo),
you will only connect a single
RCA pin-type
audio cable.
Connect
the cable t_ the VCR, then
connect the other end to the L (LEFT) audio input
on the back of
the television.
If your VCR has a video channel[ switch, set iit _;othe "OFF/AV"
mode.
See your VCR's owner's
guide for details.
Set the VCR to the playback
mode.
O Select the desired
external
input source
(EXT-1 or EXT-2) by
using the INPUT button
on the control panel
or remote
control.
Basic Connections
35
Advertisement
Table of Contents
