Using Child Lock - Mitsubishi HS-U520 Owner's Manual

Using your HS-U520to play back to another VCR
[RECORDINGI
m_ mm
tit
VIDEO IN4OtAUDIO IN R
L _---AUDIO IN L
[ PLAYBACKI HS-U520
0
Connect one RCA audio cable to the AUDIO
INPUT terminal on the other VCR. Connect
the other end of this cable to the AUDIO
OUTPUT terminal on the HS-U520 (labeled
L). If the other VCR is mono, you need a Y-
adapter to record both audio channels.
O Set the input of the other VCR to "Exte:r-
nal."
O
Put a blank tape into the other VCR and
find the place where you want to bei_n
recording. Press STOP
O
If the other VCR has stereo outputs, con-
nect another RCA audio cable to the AUDIO
INPUT terminal of the other VCR. Connect
the other end of this cable to the AUDIO
OUTPUT terminal on the HS-U520 (labeled
R).
O
Put the tape you want Locopy into the
HS-U520 and find the ]place from which you
want to begin copying. Press PLAY/STOP.
On the other VCR, press record (REC), and
then PAUSE.
O
C,onnect a video cable to the VIDEO INPUT
terminal on the other VCR. Connect the
other end of this cable to the VIDEO OUT-
F'UT terminal on the HS-U520 (labeled
VIDEO OUT).
On the HS-U520, press PlAY/STOP and
then PAUSE.
Release the PAUSE button on both VCRs at
the same time.
Set the audio monitor on the HS-U520 to
"Stereo." (See "Selecting and adjusting the
audio and video functions," on page 34.)
O Press PLAY/STOP (or STOP) on both VCRs
when you are finished.
Using Child Lock
II _111 II II
I.I _1. I.I .I.I I-I s
LOCK light
I
"1 "1sp
Important:
The child lock feature prevents others from using your VCR. To
lock the VCR:
Press and hold down the DISPLAY button on the remote
control for about 8 seconds. The LOCK light on the fluores-
cent display will light up.
To cancel the child lock, press and hold down the DIS]?LAX
button for about 8 seconds, until the LOCK light goes out.
You can lock the VCR with the power off, even if the VCR is
standing by for a programmed recording. If you lock the VCR with
no cassette in it, the VCR will not accept, a cassette.
59