Maytag MFF2055YEB00 User Instructions page 24

The water dispenser will The refrigerator is not connected to a Connect the refrigerator to the water supply and turn the
not operate properly water supply or the water supply water shutoff valve fully open.
shutoff valve is not turned on
There is a kink in the water source line A kink in the water line can reduce water flow from the water
dispenser and result in hollow or irregular shaped ice.
Straighten the water source line.
The refrigerator has just been installed Flush and fill the water system. See "Water Dispenser."
The water pressure to the house is not The water pressure to the house determines the flow from
at or above 30 psi (207 kPa) the dispenser. See "Water Supply Requirements."
A reverse osmosis water filtration A reverse osmosis water filtration system can decrease water
system is connected to your cold pressure. See "Water Supply Requirements."
water supply
A water filter is installed on the Remove filter and operate dispenser. If water flow increases,
refrigerator the water filter may be clogged or incorrectly installed.
Replace filter or reinstall it correctly.
The refrigerator door is not closed Close the door firmly. If it does not close completely, see
completely "The doors will not close completely."
The refrigerator doors were recently Make sure the water dispenser wire/tube assembly has been
removed properly reconnected at the top of the refrigerator door.
See "Refrigerator Doors and Drawer."
Water is leaking or dripping The glass was not held under the Hold the glass under the dispenser 2 to 3 seconds after
from the dispenser system dispenser long enough releasing the dispenser lever.
NOTE: A few drops of water
after dispensing is normal.
Water continues to drip The refrigerator has just been installed Flushing the water system removes the air from the lines
from the dispenser beyond which causes the water dispenser to drip. Flush the water
the first few drops, system. See "Water Dispenser."
The water filter was recently changed Flushing the water system removes the air from the lines
which causes the water dispenser to drip. Flush the water
system. See "Water Dispenser."
Water is leaking from the The water line connections were not See "Connecting the Water."
back of the refrigerator fully tightened
Recently removed the doors and did See "Refrigerator Doors and Drawer."
not fully tighten water line connection
Water from the dispenser is The refrigerator has just been installed Allow 24 hours after installation for the water supply to cool
warm completely.
NOTE: Water from the A large amount of water was recently Allow 3 hours for the water supply to cool completely.
dispenser is only chilled to dispensed
50°F (10°C) ...........................................................................................................................................................................................................
Water has not been recently The first glass of water may not be cool. Discard the first
dispensed glass of water dispensed.
The refrigerator is not connected to a Make sure the refrigerator is connected to a cold water pipe.
cold water pipe See "Water Supply Requirements."
24