Maytag MFF2055YEB00 User Instructions page 11

• Push the base grille in toward the refrigerator until it is
firmly in place. Changing the Water Filter
A
B
A. Tab
B. Clip
Door Alignment
If the space between the refrigerator doors and freezer drawer
looks uneven, you can adjust it using the following instructions:
1. Remove the top hinge cover.
2. Loosen the top hinge screws using a 5/16" s ocket or wrench.
3. Have someone hold the door in place or put a spacer
between the doors and drawer.
4. Tighten the top hinge screws once the door is in the desired
location.
5. Replace the top hinge cover.
FILTERS AND ACCESSORIES
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Water Filter Status Light
The water filter status light on the control panel will help you
know when to order and replace the water filter.
• GOOD - The water filter icon on the control lights up in BLUE.
• ORDER a replacement filter - The water filter icon on the
control lights up in YELLOW.
• REPLACE the water filter - The water filter icon on the control
lights up in RED and "Replace Filter" will appear on the
display.
• EXPIRED - The water filter icon lights up in RED and "Replace
Filter" flashes on the display.
NOTE: If water flow to your water dispenser or ice maker
decreases noticeably, change the filter sooner. The
disposable water filter should be replaced at least every
6 months, depending on your water quality and usage.
• After changing the water filter, reset the status. Press and
hold the WATER FILTER button for 3 seconds. When the
system is reset, the water filter icon will return to its BLUE
color and the words "Replace Filter" will disappear from the
display.
1. Locate the water filter in the top-right corner of the
refrigerator compartment.
2. Lift open the filter cover door. The filter will be released and
then eject as the door is opened.
3. When the door is completely open, pull the filter straight out.
NOTE: There may be some water in the filter. Some spilling
may occur. Use a towel to wipe up any spills.
4. Take the new filter out of its packaging and remove the
covers from the O-rings. Be sure the O-rings are still in place
after the covers are removed.
5. With the arrow pointing up, align the new filter with the filter
housing and slide it into place. The filter cover door will
automatically begin to close as the new filter is inserted.
6. Close the filter cover door completely in order to snap the
filter into place. You may need to press hard.
7. Flush the water system. See "Water and Ice Dispensers."
The air filter reduces the buildup of odors. This helps to maintain
a cleaner environment inside the refrigerator.
On some models, your refrigerator's accessory packet includes
an air filter, which must be installed prior to use. On some
models, the air filter is already installed at the factory.
Installing the Air Filter
Install the air filter behind the vented door, located along the rear
interior wall of the refrigerator compartment.
1. Remove the air filter from its packaging.
NOTE: An air filter status indicator is included with the air
filter. The indicator is not needed for models that display the
air filter status on the control panel.
2. Lift open the vented door.
3. Snap the filter into place.
11