Maytag MGR8670AS0 User Instructions page 15

PROBLEM POSSIBLE CAUSES SOLUTIONS
Oven burner flames are Range converted improperly If propane gas is being used, contact a service technician or
yellow or noisy see cover for contact information.
Oven temperature too high Oven temperature needs See "Oven Temperature Control" in the "Electronic Oven
or too low adjustment. Controls" section.
Convection fan not working The convection cycle is in the first This is normal. The convection fan will start running
5 minutes of operation, approximately 5 minutes into the cycle.
Oven door is open. If the oven door is opened during convention cooking, the fan
will turn off immediately. It will come back on when the oven
door is closed.
Display shows messages Power failure (display shows Clear the display. On some models, reset the clock, if needed.
flashing time) See "Clock" keypad feature in the "Feature Guide" section.
Error code (display shows letter Depending on your model, press CANCEL to clear the display.
followed by number) See "Control Display" in the "Electronic Oven Controls"
section. If it reappears, call for service. See cover for contact
information.
Start needs to be pressed so a See the "Start" keypad feature in the "Feature Guide" section.
cycle can begin (display shows
"PUSH" or "PSH").
Range is in Sabbath Mode (display Press CANCEL to exit Sabbath Mode.
shows "SAb").
Clean cycle did not work on Several cooking cycles between Run additional Clean cycles. Use the AquaLift
TM
Technology
all spills Clean cycles or spills on oven walls Cleaning Kit. Use affresh
TM
Kitchen and Appliance Cleaner or
and doors affresh
TM
Cooktop Cleaner. See the "Accessories" and "Clean
Cycle" sections for more information.
Mineral deposits are left on Tap water was used in the Clean Use distilled or filtered water in the Clean cycle.
the oven bottom after the cycle. To remove deposits, use a cloth soaked with vinegar. Then use
Clean cycle a cloth dampened with water to thoroughly remove any vinegar
residue.
Range is not level. Mineral deposits will collect on dry areas of the oven bottom
during the Clean cycle. Level the range. See the Installation
Instructions.
To remove deposits, use a cloth soaked with vinegar. Then use
a cloth dampened with water to thoroughly remove any vinegar
residue.
Oven cooking results not Range is not level. Level the range. See the Installation Instructions.
what expected
The temperature set was incorrect. Double-check the recipe in a reliable cookbook.
Oven temperature needs See "Oven Temperature Control" in the "Electronic Oven
adjustment. Controls" section.
Oven was not preheated. See "Baking and Roasting" section.
Racks were positioned improperly. See "Positioning Racks and Bakeware" section.
Not enough air circulation around See "Positioning Racks and Bakeware" section.
bakeware
Darker browning of food caused by Lower oven temperature 25°F (15°C) or move rack to a higher
dull or dark bakeware position in the oven.
Lighter browning of food caused by Move rack to a lower position in the oven.
shiny or light colored bakeware
Batter distributed unevenly in pan Check that batter is level in the pan.
Incorrect length of cooking time Adjust cooking time.
was used.
Oven door was not closed. Be sure that the bakeware does not keep the door from closing.
Oven door was opened during Oven peeking releases oven heat and can result in longer
cooking, cooking times.
Rack is too close to bake burner, Move rack to higher position in the oven.
making baked items too brown on
bottom.
Pie crusts browning too quickly Use aluminum foil to cover the edge of the crust and/or reduce
baking temperature.
15