Download Print this page

Troubleshooting - Maytag MHW6000XG0 Use & Care Manual

Front-loading automatic washer
Hide thumbs Also See for MHW6000XG0:

Advertisement

Available languages

Available languages

TROUBLESHOOTING
First try the solutions suggested
here or visit our website at www.maytag.com/help
for assistance and to possibly avoid a service call.
mfyou experience
Vibration, rocking, or
"walking"
Feet may not be in contact with the
floor and locked.
Washer may not be level.
Load coutd be unbalanced
or too large.
Front and rear feet must be in firm contact with floor, and washer
must be level to operate properly. Jam nuts must be tight
against the bottom of the cabinet.
Check floor for flexing or sagging. Hfflooring is uneven, a 3/4"
(19 mm) piece of plywood under your washer will reduce sound.
See "Level the Washer" in the hstallation
hstructions.
Avoid tightly packing the load. Avoid washing single items.
Balance a single item such as a rug or jeans jacket with a
few extra items.
Use Bulky Htemcycle for oversized, non-absorbent
items
such as comforters or poly-filled jackets. Other items are
not appropriate for Bulky Htems cycle. See "Cycle Guide".
Htem or load not suitable for selected cycle. See "Cycle Guide"
and "Using Your Washer" in this Use and Care Guide.
Clicking or metallic
noises
Gurgling or humming
Door locking or unlocking.
Objects caught in washer
drain system.
Washer may be draining water.
The door will lock unlock and lock again. You will hear three
clicks after pushing start. This is normal.
Empty pockets before wasMng. Loose items such as coins
could fall between basket and tub or may block pump.
Htmay be necessary to call for service to remove items.
Htis normal to hear metal items on clothing such as metal snaps,
buckles, or zippers touch against the stainless steel basket.
Htis normal to hear the pump making a humming sound with
periodic gurgling or surging as final amounts of water are removed
during the spin/drain cycles.
Check the following for
Fill hoses not attached tightly.
Tighten fill-hose connection.
proper installation:
Fill hose washers.
Are all four fill hose flat washers properly seated?
Drain hose connection.
Check household plumbing for leaks
or clogged sink or drain.
Water or suds leaking
Not using HE detergent or using too
from door or rear of
much HE detergent.
cabinet
Residue on door glass.
Load not completely
covered in water.
Water level not visible on door or
does not cover clothes.
Check that the drain hose is properly secured to drainpipe or
laundry tub.
Water can backup out of a clogged sink or drainpipe.
Check
all household plumbing for leaks (laundry tubs, drain pipe,
water pipes, and faucets.)
Only use HE detergent. Suds from regular detergents can
cause leaking from the door or rear of cabinet. Always measure
detergent and follow manufacturer's
directions based on your
load requirements.
Periodically clean the the underside of the glass window to
avoid potential leaks.
This is normal for an HE front load washer. The washer senses load
sizes and adds the correct amount of water for optimal cleaning.
J
16

Advertisement

loading

This manual is also suitable for:

Mhw6000xw0Mhw7000xr0Mhw7000xw0Mhw6000xr0Mhw7000xg0