Lt2002 Cloning Connections/Learning Setup - LG 22LG3DCH Owner's Manual

LT2002 CLONING CONNECTIONS/LEARNING SETUP
Connections for the LT2002 Clone Programmer to Learn the TV Master TV Setup
_" % % i / / /
/
I Antenna
or CATV
I
I
I
I
_ Warning: Do not use LT2002
while any PPV card is installed
in TV or clone programmer
device will be damaged.
Crone Programmer
Master TV
Notes: It is assumed that the TV is connected to a signal source, the source selected is Antenna (RF) In, the sig-
nal is from an Analog channel, not a digital channel, all equipment is connected to power and turned on and the
LT2002 Clone Programmer main menu (THE CLONE HAS CONTROL OF THE TV) menu is displayed on the TV
screen, see above and next page.
Before you begin cloning...
• The Master TV should be connected to a good, sta-
ble signal from an over-the-air antenna or cable ser-
vice Analog channel and connected to power. (See
above.)
• Teaching and Learning is only possible between iden-
tical model TV/STBs. (However, the LT2002 Clone
programmer can store up to 3 different 'master'
setups.)
WARNING: Copying a blank or incorrect memory into
a TV, STB or other device will cause the TV, STB or
other device to operate erratically or become inoper-
able.
• Use an Installer's remote to operate Learning and
Teaching menus.
• Make sure that the batteries in the Clone program-
mer are fresh.
• If batteries are removed, the Clone Clock time will be
lost.
• Decide if you want to set the time from the Clone
programmer or copy the time to the Clone program-
mer; from a compatible TV which has had the clock
set to the current time.
• Setting the time and transferring it to the Clone or
other device is a separate procedure.
• Follow the connection diagram above to connect the
Clone to a Master TV display panel. After learning is
complete, to another identical TV display panel to
"teach" it the master TV setup.
• See the Clone Troubleshooting section to resolve
problems.
Turn to the next page to continue Cloning
Setup.
N
0
I'rl
N
0
I-I-I
I-I-I
-t
c
97