Lt2002 Cloning Connections/Learning Setup - LG 47LD650H Manual

LT2002 CLONING CONNECTIONS/LEARNING SETUP

Connections for the LT2002 Clone Programmer to Learn the TV Master TV Setup
Antenna
or CATV
Warning
Do not use LT2002 while any PPV card is installed in TV or the clone programmer device will be dam-
G
!
NOTE
It is assumed that the TV is connected to a signal source, the source selected is Antenna (RF) In, the
G
signal is from an Analog channel, not a digital channel, all equipment is connected to power and turned
on and the LT2002 Clone Programmer main menu (THE CLONE HAS CONTROL OF THE TV) menu is
displayed on the TV screen, see above and next page.
If an analog channel is not available, tune TV to an Aux source like AV-1 for cloning purposes.
G
Before you begin cloning...
The Master TV should be connected to a good, stable
■
signal from an over-the-air antenna or cable service
Analog channel and connected to power. (See above.)
Teaching and Learning is only possible between iden-
■
tical model devices. (However, the LT2002 Clone pro-
grammer can store up to 3 different 'master' setups.)
WARNING: Copying a blank or incorrect memory into
a TV, STB or other device will cause the TV, STB or
other device to operate erratically or become inopera-
ble.
Use an Installer's remote to operate Learning and
■
Teaching menus.
Make sure that the batteries in the Clone programmer
■
are fresh.
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK = XX:XX
TV CLOCK = XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
Master TV
If batteries are removed, the Clone Clock time will be
■
lost.
Decide if you want to set the time from the Clone
■
programmer or copy the time to the Clone program-
mer; from a compatible TV which has the clock set to
the current time.
Setting the time and transferring it to the Clone or
■
other device is a separate procedure.
Follow the connection diagram above to connect the
■
Clone to a Master TV TV display panel. After learning
is complete, to another identical TV TV display panel
to "teach" it the master setup.
See the Clone Troubleshooting section to resolve
■
problems.
Turn to the next page to continue Cloning Setup.
Ferrite Core
(TDK, ZCAT
Connect cable to
2035-0930)
TV MPI Jack and
follow on screen
Status
instructions
Indicator
MPI
Color
• green battery ok
• red battery low
Blink pattern
• slow power on
no communications
• heartbeat power on
communications ok
QuickSet II Programmer
LT2002
Clone Programmer
Reset
101