Panasonic Digital Palmcorder PalmSight PV-DV910 Operating Instructions Manual page 47

The original sound can be replaced with new
sound using the built-in Palmcorder micro-
phone or an external microphone.
The AUDIO-REC setting in CAMERA MENU
mode should be as follows:
12bit The original sound is recorded on ST
(Stereo) 1, and the new sound will be
recorded on ST (Stereo) 2.
16bit The original sound is replaced with
the new sound.
• Select 12bit if you do not want the original
sound to be completely replaced during an
audio dub.
• If you dub over a tape which has both 12bit
and 16bit audio recordings on it, keep in
mind that the original 16bit audio portion
will be completely replaced.
Before you begin...
• Connect the external Microphone (if used).
• Turn On the Palmcorder.
• Insert a pre-recorded tape to be dubbed.
External Microphone
with M3 connector
(not supplied)
External
Microphone Jack
PLAY PAUSE
Set the POWER switch to VCR.
Press PLAY.
Then press PAUSE where you want
dubbing to begin.
Press A.DUB on the remote control to
put the Palmcorder in the Audio Dub
mode.
EVF Indication
A.DUB-
_nlllut, r tic c_coA_ _.
Q 0
\ I /
- A-DUB -
/ i \
(Continued on next page.)
For assistance, call 1-800-211-PANA(7262)
47