Panasonic Digital Palmcorder PalmSight PV-DV910 Operating Instructions Manual page 32

You can also use the LCD monitor to
playback your recording.
LCD-OPEN
Button
VOLUME WHEEL
Built-in Speaker
i
REWIND STOP PLAY
SEARCH Button Button
Button
Before you begin...
• Connect the Palmcorder to a power source.
• Insert a recorded cassette.
• Set the Power Switch to VCR,
Press the LCD-OPEN Button to unlock
the LCD monitor and swing open.
Press REWIND/SEARCH to rewind the
tape.
Press PLAY to start playback.
To adjust the volume:
Hold down the VOLUME WHEEL until
the volume setting screen appears.
Then rotate the wheel to adjust the
volume of the built-in speaker.
• Adjust the picture on the LCD monitor
if needed. (see page 28)
Press STOP to stop playback.
• When the tape reaches its beginning
during rewind or rewind search, it will
stop automatically.
• If you press PLAY for more than 5
seconds, the Palmcorder will start the
Repeat Playback mode when the tape
reaches its end. The letter "R" will
appear in the EVF. ---- ,_
To exit the Repeat
mode, turn the
Palmcorder OFF.
I; -- :i I
You can place the Palmcorder on a table,
etc. for viewing. Rotate the LCD Monitor
!80 ° and swing it up against the
Palmcorder body as shown,
Note:
• When a tape recorded in LP mode on
another digital video camera is played
back on this unit, the picture may appear
mosaic.
• Using the LCD monitor reduces battery
operating time,
32
For assistance, call 1-800-211-PANA(7262)