Wireless Speakers Connection; Led Indicator Of Wireless Receiver; Setting Up Receiver For First Time; Manually Pairing Wireless Receiver - LG Smart 3D Blu-Ray BH6830SW Owner's Manual

14 Connecting
Wireless speakers connection
LED indicator of wireless receiver
LED Color Operation
Yellow The wireless receiver is receiving
the signal of the wireless TX.
Red The Wireless Receiver is in
standby mode.
Off (No The power cord of wireless
display) receiver is disconnected.
Setting up the wireless receiver for
the first time
1. Connect theWireless Receiverand the rear
speaker (right, left) with the speaker cables.
Color Speaker Position
Grey Rear Rear right
Blue Rear Rear left
2. Connect the power cord oftheWireless
Receiver to the outlet.
3. Turn off the unit and insert the Wireless TX into
theW[RELESS connector on the rear of the unit.
4. Turn on the main unit:The main unit and
wireless receiver will be automatically
connected.
-- _._ Caution
Insert the Wireless TX with the marked
"Wireless TX" facing upwards to rear on the
unit.
Insert the Wireless TX to the line on the
Wireless TX into the WIRELESS connector on
the rear of the unit.
• Do not insert a wireless dongle other than
the Wireless TX dongle dedicated for the
product.The product might be damaged or
it may not be removed easily.
Manually pairing wireless receiver
When your connection is not completed, you can
see the red LED on the wireless receiver and rear
speakers are not made sound.To solve the problem,
follow the below steps.
1. Press and hold [] STOP button on the unit
and u(_ MUTE button on the remote control
simultaneously.
- Displays the"REMATE'.
2. Press PAIRING on back of the wireless receiver.
-The yellow LED will flicker
3. Turn offand on the unit.
- If you see "yellow" LED, it's successful.
4. If you don't see "yellow" LED, try again Step I -
Step 3.
- @ Note
• ffyou operate main unit then wireless
receiver (rear speakers) sound within a few
seconds in standby mode.
Set the distance between this unit and
wireless receiver within 10 m (32 ft.).
Optimum performance can be
implemented only when the unit and the
wireless receiver within distance of 2 m (6 ft.)
to 10 m (32 ft.) is used since communication
failure may occur if longer distance is used.
It takes a few seconds (and may take longer)
for the Wireless TX and wireless receiver to
communicate with each other.