Panasonic Palmcorder IQ PV-A306 Manual page 4

Hide thumbs Also See for Palmcorder IQ PV-A306:
Table of Contents

Advertisement

15. Power Lines -- An outside antenna
system should
not be located in the vicinity of overhead power
lines or other electric light or power circuits, or
where it can fall into such power lines or cimuits.
When installing
an outside antenna
system,
extreme
care should be taken to keep from
touching such power lines or circuits as contact
with them might be fetal,
16. Overloading
-- Do not overtoad well outlets and
extension cords as this can result in a risk of flre or
electdc shock.
17. Objects
end Liquids -- Never push objects of any
kind into this video unit through
openings
as they
may touch dangerous
voltage points or short out
parts that could result in a fire or electric shock.
Never spill liquid of any kind onto the video unit,
18. Servicing
-- Do not attempt to service this video
unit yourself as opening or removing covers may
expose you to dangerous
voltage or other hazards_
Refer aU servicing to qualified
service personnel,
19, Damage Requiring
Service
-- Unplug this video
unit from the wall outlet and refer servicing
to
qualified
service personnel under the following
conditions:
a. When the power-supply cord or plug is
damaged.
b- If any liquid has been spilled onto, or objects
have fatten into the video unit,
c. If the video unit has been exposed to rain or
water.
d. If the video unit does not operate normally
by
following
the operating
instructions.
Adjust only
those controls that are covered by the operating
instructions,
as an improper adjustment of other
controls
may result in damage and will often
require extensive work by a qualified
technician
to restore the video unit to its normal operation,
e, If the video unit has been dropped or the cabinet
has been damaged,
t. When the video unit exhibits a distinct
change
in
performance
-- this indicates
e need for service,
20. Replacement Parts -- When replacement parts are
required,
be sure the service technician has used
replacement parts specified
by the manufacturer
or
have the same Characteristics
es the original part.
Unauthorized
substitutions
may result in fire,
electric shock or other hazards.
21. Safety Check--
Upon completion of any service or
repairs to this video unit, ask the service technician
to perform safety checks to determine
that the
video unit is in safe operating
order.
USE & LOCATION
- TO AVOID SHOCK
HAZARD
... Your Camcorder
and power supply should not be exposed to rain or moisture.
DO not connect the power supply or operate your Camcorder
ifit gets wet. Your Camcerder
has been designed
for OUtdoor use, however
it is not designed
to sustain direct exposure
to water, rain, sleet, snow, sand, dust, or a
direct splashing from a pool or even e cup of coffee. This action could permanently
damage the internal parts of
your Gamcorder.
Do not attempt to disassemble
this unit, There ere no user serviceable parts inside, Unplug
your Camcorder
from the power supply before cleaning.
• DO NOT AIM YOUR CAMCORDER
AT THE SUN OR OTHER BRIGHT OBJECTS
• DO NOT LEAVE THE PALMCORDER
WiTH THE EVF AIMED DIRECTLY
AT THE SUN AS THIS MAY
CAUSE
DAMAGE
TO THE INTERNAL
PARTS OF THE EVF
- DO NOT EXPOSE
YOUR CAMCORDER
TO EXTENDED
HIGH TEMPERATURE
._ Such as, in direct sunlight.
inside a closed car, next to a heater, etc..,
This action could permanently damage the internal
parts of your
Camcorder.
- AVOID SUDDEN
CHANGES
IN TEMPERATURE
_. I! the unit is suddenly moved from a cold place to a warm
place, moisture
may form on the tape end inside the unit.
• DO NOT LEAVE YOUR CAMCORDER
OR THE POWER
SUPPLY TURNED
ON WHEN NOT IN USE.
• STORAGE
OF YOUR CAMCORDER
... Store and handle your Camcorder in a manner that will not subject it to
unnecessary
movement (avoid shaking and striking). Your Camcorder
contains a sensitive
pick-up device which
could be damaged
by improper
handling Or storage.
CARE
. TO CLEAN
YOUR CAMCORDER
... 0o not use strong or abrasive
detergents when cleaning your Cemcorder
body.
• TO PROTECT
THE LENS ,.. Do not touch the surface
of the lens with your hand. Use a commercial
camcorder
lens solution and lens paper when cleaning
the lens, Improper cleaning
can scratch the lens coating,
. TO PROTECT
THE FINISH OF YOUR CAMCQRDER.,
Before
handling your Camcorder,
make sure your
hands and face are free from any chemical products,
such as suntan lotion, as it may damage the finish.
4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents