Panasonic Palmcorder IQ PV-A306 Manual page 30

Before you begin...
• Connect the Palmcorder as shown below.
• Connect the Palmcorder to VCR.
• Turn ON both units.
• Set the recording VCR's Input Signal
Selector to LINE.
Insert a pre-recorded tape
into the source (playing)
Palmcorder and a blank tape with
record tab into the recording unit.
• Set the Palmcorder POWER switch to VCR.
2Press PLAY on the (playing)
Palmcorder. Press STILL when the
tape reaches the point you want to start
dubbing.
Press PLAY and REC together
then immediately press STILL on
Source (Playing) the recording unit.
Patmcorder
Audio/Video Out
--Audio/Video Cable
(supplied)
__
To Audio In
--VHF Connecting Cable
(not supplied)
II III II II
• Turn the TV ON and select its VCR
channel (either CH3 or CH4).
• Set the VCR/"I_V Selector on the
recording VCR to VCR.
3O
Press STILL on the playing
Palmcorder and PAUSF_JSTILL
on the recording unit to begin
copying your tape.
Press STOP on both units
when dubbing is complete.
v. rdin
Note:
• Tapes recorded on other VCRs and
used for playback in the Palmcorder
must be recorded in SP or SLP mode.
• For technical reasons, dubbing a tape
may reduce its quatity.
IcUCAUTION:
_t
nauthodzed exchanging and/or copying of|
opyrighted recordingsmay be copyright
J
,,n{ri,ng,,ement.