Table of Contents
Advertisement
Before
Use:
• Check the camera for foreign material
including dirt, dust or sand.
• Be sure to close the battery/card compartment
cover and connector cover firmly so that each
lock makes clicking sound.
• Do not open the battery/card compartment
cover and connector cover with wet hands,
while under water, or in a damp or dusty
environment (e.g. beach).
After
Use:
Be sure to wipe off any excess
water or debris
after using the camera
under water.
• After
the camera
is used
under
seawater,
immerse
the camera
in a bucket
containing
fresh
water
for about
10 minutes
(with
the battery/card
compartment
cover
and
connector
cover
firmly
closed).
After
that,
dry the camera
in a shade
with
good
ventilation.
• Water
drops
may
be observed
on the inner
surface
of the battery/card
compartment
cover
or connector
cover
after
you
open
each cover.
If any water
drops
are found,
be sure
to wipe
them
off
before
using
the
camera.
Notes after use
• Foreign materials may be attached to the
periphery of the lens cover from using the
camera in conditions with foreign materials
such as dirt, dust or sand, or when the lens
cover is not moving smoothly. If you continue
to use the camera in such conditions, the lens
could become damaged or the lens cover
could stick causing additional damage to the
camera. To avoid such damage, wash the
camera using the following method.
J_,Insert the battery and close the battery/
card compartment cover and connector
cover firmly so that each lock makes the
clicking sound.
(2 Fill a bucket with fresh water, immerse
the camera in the bucket with the lens
surface downward and shake the camera
thoroughly.
(3_Press the ON/OFF button several times in
the water and close/open the lens cover
repeatedly.
(4j Furthermore, shake the camera further
with the cover opened.
Follow the Steps _ to 4_,,then check if the
lens cover moves smoothly.
If the lens cover does not move smoothly,
rinse the lens face by placing it directly under
a strong stream of tap water and pressing the
ON/OFF button repeatedly.
Storage
and
Maintenance
• Do not leave the camera
in an environment
at
high temperature
(40°C (104°F)
or more)
or at
low temperature
(-10°C
(14°F)
or tess).
Failure
to do so may break
down water
resistance.
• Do not use chemicals
for cleaning,
rust
prevention,
anti-fogging,
repairing,
etc. Failure
to do so may
break
down water
resistance.
• Do not leave
the camera
in water
for a long
time.
Failure
to do so will
cause
damage
to
the camera's
appearance
and/or
deteriorate
water
resistance.
• In order
to preserve
the water
resistant
feature,
as with
any underwater
housing,
it is recommended
that the waterproof
packing
(and
seals)
are replaced
annually.
For the Olympus
distributors
or service
stations
where
the waterproof
packing
can
be replaced,
visit
Olympus
website
for your
local
area.
EN
Advertisement
Table of Contents
