NordicTrack CX 985 User Manual page 8

8. Locate oneofthe Handlebar Covers (26).Lookinside
ofthe Handlebar Cover a ndlocatethesquare tabs
connecting t hetwohalves. G ently liftthetabsanddis-
connect t hehalves.
Holdthetwohalves ofthe Handlebar Cover ( 26)
around thetubeontheleftsideofthe Upright (2).Align
thehalves andpressthemtogether u ntil t heylock.
Attach theotherHandlebar Cover(26)tothe right s ide
ofthe Upright ( 2)inthesameway.
Holdthehalves ofthe Upper Handlebar Cover ( 25)
around thetubeonthefrontofthe Upright ( 2);be
carefulnot to damagethe PulseSensorWiresor
the PulseExtension Wire (notshown).Attachthe
Upper Handlebar Cover w ithan M4x 12mm Screw
(96).
9. Haveanother p erson holdtheConsole (17)nearthe
Upright ( 2).
Connect t heUpper W ireHarness (115) t o thewirehar-
nessonthe Console (17).Connect the Pulse
Extension W ire(114) t o thepulse wireontheConsole.
Next,locate thetwoground wiresthatareattached
witha screwtothe Upright ( 2).Connect theground
wiresto thetwosmallest wiresontheConsole.
Carefully insert a llexcess wiringupintotheConsole
(17)anddownintotheUpright ( 2).AttachtheConsole
tothe Upright w ithfourM4x 16mm Screws (98).
(Note: T heScrews maybe shipped inthe console
box.)Be carefulto avoid pinchingthe wires.
10.Plug thePower C ord(116)intothePower S ocket
(117) a t therearof theelliptical exerciser.
10
25
96
26
Do
not pinch
the wires
during this step.
114
\
11. Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the
elliptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.
The elliptical exerciser is now fully assembled. If you have purchased the optional chest pulse sensor
(see page 21), refer to page 9 of this manual.