Cycle Option Buttons; Custom Program - LG DLGX5102V Owner's Manual

OW TO USE
CYCLE OPTION BUTTONS
Your dryer features several additional cycle
options to customize cycles to meet your
individual needs. Certain option buttons also
feature a special function that can be activated by
pressing and holding that option button
for 3 seconds.
TO
O
O
O
Add Cycle Options to a Cycle:
Turn on the dryer and turn the cycle selector
knob to select the desired cycle.
Use the cycle settings buttons to adjust the
settings for that cycle.
Press the cycle option button for the option
you would like to add. A confirmation
message will be shown in the display.
O Press the START/PAUSE button to start the
cycle. The dryer will start automatically.
DAMP DRY BEEP
With this option, the dryer
will beep when the load is
approximately 80% dry. This
allows you to remove faster-
drying lightweight items or
items that you would like to
iron or hang while still slightly
damp.
WRINKLE CARE
Selecting this function will
tumble the load periodically
for up to 3 hours after the
selected cycle, or until the
door is opened. This is helpful
in preventing wrinkles when
you are unable to immediately remove items from
the dryer. Press and hold the DAMP DRY BEEP
button for 3 seconds to activate or deactivate the
WRINKLE CARE function.
CHILD LOCK
Use this option to prevent
unwanted use of the dryer or
to keep cycle settings from
being changed while the dryer
is operating. Pressand hold the
EASYIRONbutton for 3 seconds
to activate or deactivatethe CHILD LOCKfunction. The
lock icon will be shown in the display,and all controls are
disabled except the ON/OFFbutton.
NOTE:If the dryer is powered on again, the CHILD LOCK
function stays on. To releasethat function, while your
dryer is running,you set the CHILD LOCKfunction ONCE.
TO Install the Drying Rack
O With the dryer door open, slide the rack into
the dryer drum.
Make sure it is seated evenly on the edge
of the inner door rim and resting flat on the
inside of the dryer.
NOTE: Be sure to remove the drying rack
after using the RACK DRY cycle.
CUSTOM PROGRAM
If you have a special
combination of settings that
you use frequently, you can
save these settings as a
CUSTOM PROGRAM.
NOTE: You may only save one custom program
at a time. Pressing and holding the CUSTOM
PROGRAM button will overwrite any previously
saved custom program.
TO Save a Custom Program:
Turn on the dryer and turn the cycle selector
knob to select the desired cycle.
e use the cycle setting buttons to adjust the
settings for that cycle.
Press the cycle option button(s) for the option
you would like to add. A confirmation
message will be shown in the display.
Press and hold the CUSTOM PROGRAM
button for 3 seconds.
TO Recall a Custom Program:
Turn on the dryer.
O Press the CUSTOM PROGRAM button.
O Press the START/PAUSE button to start
the cycle.
5t