MTD 600 Series Operator's Manual page 19

Auger Shaft
At least once a season, remove the shear pins from the auger
shaft. Spray lubricant inside the shaft and around the spacers and
the flange bearings found at either end of the shaft.
See Fig. 6-3.
I __ o
k. j
Figure 6-3
Adjustments
Shift Cable
If the full range of speeds (forward and reverse) cannot be
achieved, refer to the figures to the right and adjust the shift
cable as follows:
1.
2.
Place the shift lever in the fastest forward speed position.
Loosen the hex nut on the shift cable index bracket. See
Fig. 6-4.
Figure 6-4
3. Pivot the bracket downward to take up slack in the cable.
4. Retighten the hex nut.
AugerControl
Refer to the Assembly and Set-up section for instructions on
adjusting the auger control cable.
ChuteAssembly
Refer to the Assembly and Set-up section for instructions on
adjusting the chute assembly.
Skid Shoes
Refer to the Assembly and Set-up section for instructions on
adjusting the skid shoes.
SECTION 6 -- MAINTENANCE & ADJUSTMENTS
19