Advertisement
Controls a nd Features
4
Drive Control
Shift Lever
er Control
Chute Assembly
\\
Gas Cap
\
Clean Out
Tool
\
\
\
Augers
Skid Shoe
Figure 4-1
Snow thrower
controls
and features
are described
below and
illustrated
in Fig. 4-1.
NOTE: For detailed
information
on all engine controls,
refer to
the separate
Briggs & Stratton
Engine Operator's
Manual.
Primer
\
Choke
Control
Ignition
Key
Stop
Recoil Starter
Handle
Shift Lever
21
12345
6
The shift lever is located
in the right side of the handle panel and
is used to determine
ground
speed and direction
of travel.
Forward
il Fill
Electric Start
Button
Electric Starter
Outlet
_=_
_=J
J
ChokeControl
The choke control
is found
on the rear of the engine and is
activated
by rotating
the knob. Activating
the choke control
closes the choke plate on the carburetor
and aids in starting
the
engine.
Ignition Key
The ignition
key is a safety device. It must be fully inserted
in
order for the engine
to start. Remove the ignition
key when the
snow thrower
is not in use.
Note: Do not turn the ignition
key in an attempt
to start the
engine. Doing so may cause it to break.
There are six forward
(F) speeds. Position one (1) is the slowest
and position
six (6) is the fastest.
Reverse
There are two reverse (R) speeds. One (1) is the slower and two (2)
is the faster.
11
Advertisement
