Dell Studio Desktop Service Manual page 14

12. Replace the front panel (see
13. Replace the computer cover (see
14. Connect your computer and devices to their electrical outlets, and turn them on.
NOTE: If you installed a new drive, see the documentation that came with the drive for instructions on installing any software required for drive
operation.
Replacing the FlexDock
1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Remove the front panel (see
1 custom screws (2)
3 FlexDock USB cable
4. Disconnect the FlexDock USB cable from the back of the FlexDock and from the internal USB connector (F_USB1) on the system board (see
Components).
5. Remove the two screws securing the FlexDock.
6. Slide the FlexDock out through the front of the computer.
7. If you are not replacing the FlexDock, replace the drive panel insert (see
8. If you are installing a new FlexDock:
a. Remove the drive panel insert, if applicable (see
b. Remove the FlexDock from its packaging.
9. Gently slide the FlexDock into place in the FlexDock slot.
10. Align the screw holes in the FlexDock with the screw holes in the FlexDock.
11. Replace the two screws that secure the FlexDock.
NOTE: Ensure that the FlexDock is installed before the FlexDock cable is connected.
12. Connect the FlexDock USB cable to the back of the FlexDock and to the internal USB connector (F_USB1) on the system board (see
Components).
Replacing the Front Panel).
Replacing the Computer Cover).
Begin.
Replacing the Computer Cover).
Replacing the Front Panel).
2 F_USB1 connector
4 FlexDock
Replacing the Drive Panel
Replacing the Drive Panel Insert).
Insert).
System Board
System Board