SECTION 3: HARDWARE P ACK
B
B
B
B
-©@®
-©@®
-©@@
-©@®
Group I
Group 2
Group 5
r_
L;_;J
Group 3
Group 4
@
Group 6
SECTION 4: ASSEMBLING YOUR LAWNMOWER
NOTE:
This operator's manual covers various models
of mowers. Follow only those instructions which pertain
to your unit.
ToRemove UnitFromCarton
•
Remove staples, break glue on top flaps, or cut tape
at carton end and peel along top flap to open carton.
•
Remove loose parts, if included with unit.
•
Cut along corners and lay carton down flat.
•
Remove packing material. Roll or slide unit out of
carton. Check carton thoroughly for loose parts.
ToolsRequired
A set of adjustable wrenches or individual wrenches of
the following sizes:7/16", 1/2", 9/16", 3/4".
NOTE:
Reference
to right or left hand side of the
mower is observed from the operating position.
Disconnect SparkPlugWire
_L,
WARNING:
Disconnect the spark plug wire
and ground it against the engine to prevent
unintended starting.
NOTE:
On engines with a rubber boot, attach rubber
boot to a bolt on the engine to ground
Figure 1
IMPORTAWI':This unit is shipped without gasoline or oil
in the engine. Do not start the engine before filling up
gasoline and oil.
IMPORTAWI': Before starting to assemble the unit,
identify the items of the hardware pack according to the
groups in Section 3 on this page. These same groups
are referred to in the subsequent assembly instructions.
Attaching LowerHandle
•
Lift the rear of the deck and place it on a block
securely.
•
Place the lower handle (pointed end will face down)
over the deck and align the holes on the deck with
the corresponding
holes on the handle.