Adding Fuel; Adding Oil - MTD 31A-2M1A729 Operator's Manual

Single-stage snow thrower
Table of Contents

Advertisement

Available languages

Available languages

Adding Fuel
WARNING!
Use extreme
care when handling
gasoline. Gasoline
is extremely
flammable
and the
vapors are explosive.
Never fuel the machine
indoors or while the engine
is hot or running.
Extinguish
cigarettes,
cigars, pipes and other
sources of ignition.
WARNING!
Always keep hands and feet clear of
equipment
moving
parts. Do not use a pressurized
starting
fluid. Vapors are flammable.
Remove the gas cap, check the fuel level and add fuel if
necessary.
Adding Oil
1.
CAUTION:
The engine
may be shipped
with a small
amount
oil in the engine. You must be sure to fill the
engine
with oil between
the high and low marks on
the dipstick
before operating.
Running the engine
with insufficient
oil can cause serious engine
damage and void the engine warranty.
Place the snow thrower
on a flat, level surface.
2.
Remove the oil filler cap/dipstick
and wipe the dipstick
clean. See Fig. 3-3.
_erLeve!
NOTE: Do not screw in the dipstick
when checking
the oil level.
3.
Slowly add oil until the level registers between
high (H) and
low (L) Fig. 3-4.
f
H
Figure 3=4
NOTE: Refer to the Engine Maintenance
section for the correct oil
viscosity
and engine
oil capacity.
NOTE: Do not overfill.
Overfilling
the engine with oil may result
in the engine
smoking,
hard starting
or spark plug fouling.
Figure
3-3
8
I
SECTION3--
ASSEMBLY&
SET-UP

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

31a-2m1a70031a-2m1a7622m1

Table of Contents