Maytag MER6871AAW User Manual page 14

MAIHTEHAH(E
OVEN DOOR(S)
Do not place excessive weight on or
stand on an open oven door. This
could cause the range to tip over,
break the door, or injure the user.
Do notattempt toopen or close door
or operateoven untildoor is properly
replaced.
Never place fingers between hinge
and front ovenframe. Hingearms are
spring mounted, if accidentally hit,
the hinge will sfam shut against oven
frame and could injure your fingers.
Both the upper and lower oven doors are
removable.
To REMOVE:
1. When cool, open the oven door to the
broil stop position (opened about four
inches).
2. Graspdoor at each side. Do not use the
door handle to lift door.
3, Lift up evenly until door clears hinge
arms.
To REPLACE:
1. Grasp door at each side,
2. Align slots in the door with the hinge
arms on the range.
3. Slide the door down onto the hingearms
untilthe door is completelyseated on the
hinges. Pushdownon the top corners of
the door to completely seat door on
hinges, Doorshouldnotappear crooked.
NOTE-:The oven door on a new range may
fee! "spongy" when it is closed.This is nor-
real and will decrease with use.
OVEN WtNOOW(S)
To protect the oven door window:
1. Do not hit the glass with pots, pans,
furniture,toys, or other objects.
2 Do not close the oven door until the
oven racksare inplace.
Scratching,hitting,jarring or stressingthe
glass may weaken its structurecausingan
increasedrisk of breakageat a taterdate.
LEYELIH5 LEGS
> Be sure the anti4ip bracket secures
one of the rear leveling legs to the
floor. This bracket prevents the range
from accidentally tipping.
The range should be leveled when installed.
If the range is not level, turn the plastic
leveling legs, located at each corner of the
range, until range is level.
_TIP BRACKET
__ _" LEVELING LEG
Ovl N LiGHT(S)
To assure the proper replacement
bulb is used, order bulb from Maytag
Customer Service. Call 1-800-688-
8408, ask for part number 74004458 -
halogen bulb.
Disconnectpower to range
before replacing light bulb.
Allow oven to cool before
replacing light bulb.
> Make sure bulb cover and bulb
are cool before touching.
To REPLACEOVEN LIGHT
BULB:
1. When oven is cool, use fingertips to
grasp edge of bulb cover, Pull out and
remove.
1
.
Carefully remove old bulb by pulling
straight out of ceramic base.
To avoid damaging or decreasing the
life of the new bulb, do not touch the
bulb with bare hands or fingers. Hold
with a cloth or paper towel, Push new
bulb prongsstraight into small holes
of ceramic base.
4. Replace bulb cover by snapping into
place.
5, Reconnect power to the range. Reset
clock.
COHYEHI[HCE OUTLET
(CANADIAN MOOELS ONL',')
The convenienceoutlet is located on the
lower left side of the backguard.
Be sure appliancecords do not rest on or
near the surface element. If the surface
elementis turnedon,thecordandoutletwill
be damaged.
Theconvenienceoutletcircuitbreakermay
trip if the small appliance plugged into it
exceeds 10 amps, To reset the circuit
breaker, press the switch located on the
loweredge of the backguard.
t_.L..,_L,j.,: ":_._,J.;°
4,5.6 4. 5 * 6
.... 1_ .........
CIRCUIT BREAKER SWITCH
1}