Baking - Maytag MER5775RAQ1 Use & Care Manual

To recall the time of day when another time function is
showing, press the Clock pad.
Clock time cannot be changed when the oven has been
programmed for Delay Cook or Delay Clean or Cook & Hold.
To cancel the Clock display:
If you do not want the time of day to display:
Press and hold the CANCEL and Clock
pads for three seconds. The time of day
will disappear from the display.
When the clock display is canceled, press
the Clock pad to briefly display the time
of day.
When the clock display is canceled, after 15 minutes, the oven
control will go into Standby Mode to save energy. The displaywill
be blank and the oven light will not operate. To "wake up" the
control from Standby Mode, press any touchpad. A double beep
will sound.
To restore the Clock display:
Press and hold the CANCEL and Clock pads for three
seconds. The time of day will reappear in the display.
Timer
The timer can be set from one minute (0:01) up to 99 hours
and 59 minutes (99:59).
The timer can be used independently of any other oven
activity. It can also be set while another oven function is
operating.
The timer does not control the oven. It only controls a beeper.
To set the Timer:
1. Press the Timer pad.
• 0:00 and TIMER flash in the display.
2. Press the appropriate number pads until the correct time
appears in the display.
° The colon and TIMER will continue to flash.
3. Press Timer pad again or wait four seconds.
• The colon stops flashing and the time begins counting
down.
° The last minute of the timer countdown will be displayed
in seconds.
4. At the end of the set time, one long beep will sound and
"End" will be displayed.
5. Press the Timer pad to clear the display.
To cancel the Timer:
1. Press and hold the Timer pad for three
seconds.
OR
(-_
2. Press the Timer pad and press '0' using the U
number pads. Au[oset
Locking the Control
and Oven Door
The touchpad and oven door can be locked for safety,
cleaning, or to prevent unwanted use. The touchpads will not
function when locked.
If the oven is currently in use, the touchpads and door cannot
be locked.
The current time of day will remain in the display when the
touchpads and door are locked.
To lock:
Press and hold the CANCEL and Cook & --('r'&ktr'_l_
Hold pads for three seconds. (Press
CANCEL pad first.)
• OFFappears in the display.
° LOCK flashes while the door
is locking.
To unlock:
Press and hold tile CANCEL and Cook & Hold pads for three
seconds. (Press CANCEL pad first.) OFF disappears from the
display.
Note: The touchpads and oven door cannot be locked if the
oven temperature is 400° F or above.
Fault Codes
BAKE or LOCK may flash rapidly in tile display to alert you if
there is an error or a problem. If BAKE or LOCK flash in the
display, press CANCEL pad. If BAKE or LOCK continue to flash,
disconnect power to the appliance. Wait a few minutes, and
then reconnect power. If the flashing still continues, disconnect
power to the appliance and call an authorized servicer.
Baking
To set Bake:
1. Press the Bake pad.
° BAKE will flash.
• 000 will flash in the display.
2. Select the oven temperature. Press the U
Autoset 0 pad for 350° F or the appropriate Autoset
number pads.
° Each additional press of the Autoset 0 pad will increase
the temperature by 25°.
• The oven temperature can be set from 170° to 550°.
3. Press Bake pad again or wait four seconds.
• BAKE will stop flashing and light in the display.
• 100° or the actual oven temperature if over 100° F will
display. It will rise in 5° increments until the preset
1 3 temperature is reached.