8. TROUBLESHOOTING
8-1. SAFETY CAUTION
•
There's
built-in AC 120V and DC power in output terminal
of PWB assembly
in common.
Be careful
electric
shock when disconnecting
parts while trouble
shooting.
(Wear Electro Static Discharge
gloves
when working.)
•
After cutting off the power when changing
PWB assembly,
disconnect
or assemble.
•
Be careful static when handling
PWB assembly,
and use Electro Static Discharge
plastic pack when
delivering
or keeping
it.
8-2.ERROR
MODE SUMMERY
• If you press the START/PAUSE
button when an error is displayed,
any error except
will
disappear
and the machine
will go into the pause status.
• In case of
,
,
if the error is not resolved
within 20 seconds,
or the in case of other
errors, if the error is not resolved
within 4 minutes,
power will be turned off automatically
and the error
code will blink. But in the case of
, power will not be turned off.
ERROR
WATER INLET
ERROR
IMBALANCE
2
ERROR
DRAIN
3
ERROR
OVER FLOW
4
ERROR
5
6
7
PRESSURE
SENEOR
ERROR
DOOR OPEN
ERROR
HEATING
ERROR
SYMPTOM
CAUSE
• Correct water level (246) is not reached within 8 minutes
after water is supplied or it does not reach the preset water
level within 25 minutes.
• The load is too small.
• The appliance is tilted.
• Laundry is gathered to one side.
• Non distributable things are put into the drum.
• Not fully drained within 10 minutes.
• Water is overflowing (water level frequency is over 213).
• _ If
is displayed, the drain pump will operate to drain
the water automatically.
• The SENSOR SWITCH ASSEMBLY is out of order.
• Door not all the way closed.
• Loose electrical connections at Door switch and PWB
Assembly.
• The DOOR SWITCH ASSEMBLY is out of order.
• The THERMISTOR
is out order.
2O