Using The Control; Refrigerator Features; Split-Level Shelf; Lower Shelf - KitchenAid KBCO06XPBL00 Use & Care Manual

For y our c onvenience, yourrefrigerator control is preset atthe
factory. When you firstinstall yourrefrigerator, make sure thatthe
control isstillpreset tothemid-setting asshown.
Corder
Adjusting Controls
The mid-setting indicated in the previous section should be
correct for normal usage. The control is set correctly when
beverages are as cold as you like.
If you need to adjust the temperature, wait at least 24 hours
between adjustments and then recheck the temperature.
To make the refrigerator colder, adjust the control to the next
higher setting. To make the refrigerator less cold, adjust the
control to the next lower setting.
REFRIGERATOR FEATURES
_mportant information to know about glass she_ves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
For your protection, tempered glass is designed to shatter
into many small, pebble-size pieces. This is normal. Glass
shelves and covers are heavy. Use speciaI care when
removing them to avoid impact from dropping.
Your refrigerator has an adjustable split-level shelf for maximum
storage capability.
To Remove and Replace Shelf:
1. Remove the shelf by lifting it up out of the shelf clip.
2. Replace the shelf by aligning it over the clips and pressing it
into place.
To Remove and Replace Lower Shelf:
1. Remove the shelf by lifting it up and pulling it forward.
2. Replace the shelf by lowering it on the guides.
To Remove and Replace Wire Storage Bin:
1. Remove the bin by pulling it forward.
2. Replace the bin by sliding it back into place.
DOOR FEATURES
To Remove and Replace Can Rack
1. Remove the can rack by tilting it forward and pulling it out.
2. Replace the rack by placing the rear of the rack under the
support on the door and sliding into place.
10
The door bin can be positioned either on the upper door or the
lower door.
To Reposition the Door Bin:
1. Remove the door bin by tilting it forward and pulling it out.
2. Replace the bin by placing the rear of the bin under the
support on the door and sliding into place.
!