Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION
INSTRUCTIONS
•
It is recommended
that the vent system be installed before
hood is installed.
•
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for exhaust vent.
•
Check that all installation parts have been removed from the
shipping carton.
1. Disconnect
power.
2. Determine which venting method to use: roof, wall or rear
exhaust.
3. Select a flat surface for assembling the range hood. Place
covering over that surface.
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
4. Using 2 or more people, lift range hood onto covered surface.
Optional Backsplash Installation
The following instructions
are for the backsplash without shelves.
If you are installing the Optional Backsplash with Shelves for Heat
Lamps, follow the instructions
included with that product.
The hardware package supplied with the kit includes 4 plastic
wall anchors and mounting screws.
NOTE: The minimum height of the hood above the cooktop is
30" (76.2 cm). The backsplash can be extended from 1923/32 ' '
(50.1 cm) to 39" (99.1 cm). As the 30" (76.2 cm) installation
height increases, the hood's capture area decreases.
•
Determine height of the hood.
•
For ease of installation, use 2 or more people to position the
backsplash on the wall so that the top of the backsplash is at
the height of the bottom edge of the hood. Mark the location
of the four corner holes. It is recommended
that the
backsplash
be attached to the wall at all four corners.
However, the lower flange can be secured between the wall
and backspash, countertop or cabinet base without using the
bottom corner screws.
•
Drill 5A6"(8 mm) holes.
•
Push plastic wall anchors all the way into the holes.
•
Position the holes in the backsplash over the wall anchors
and attach using the screws supplied.
The hood comes from the factory with the exhaust collar on top
of the hood. The hood exhaust may be directed out the rear of
the hood through the exhaust collar. If you desire to have the
hood exhaust out the rear, follow the procedure below.
1.
From inside the hood, unplug wire attached to blower motor.
A
B
A. Blower motor
B. Blower motor plug
2. Turn the hood over and remove the screws holding the
exhaust blower assembly to the hood.
A
?
A. Blower motor
B. Screws
3. Rotate the blower assembly so that the exhaust collar is
facing out the back of the hood.
A
A. Exhaust blower assembly
B. Screws
C. Exhaust collar
4. Replace the screws holding the blower assembly to the hood.
5. Plug the blower motor wire back into the blower motor.
8
Advertisement
Table of Contents
