Advertisement
Available languages
Available languages
•
CAUTION
When
you remove
the end caps, a
small metal
washer
on each
end
may come off, DO NOT lose these
two metal
washers.
u
TO CLEAN AGITATOR
NOTE: In order to keep cleaning
efficiency
high and to prevent damage to your vacu-
um, the agitator must be cleaned every time
the belt is chanqedd.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum
Use
Clean Agitator
HEAVY
-
every week
(used daily)
MODERATE
-
every month
(used 2-3 timeslweek)
LIGHT -
(used 1 timelweek)
every 2 months
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully
remove
any string or debris
located
on the agitator,
end caps, wash-
ers or agitator
shaft.
iMPORTANT
Replace
the
washers
and
the end caps.
See the explod-
ed view for cor-
rect
assembly.
Disconnect
cleaner from electrical
outlet.
Check and remove hair, string and lint build-
up frequently
in the Power-Mate e agitator
and end cap areas_ If build-up becomes
excessive, disconnect
Power-Mate ® from
wand and follow the steps below.
TO REMOVE BELT
i
3, Turn Power-
Mate ® right side
up Press handle
release pedal and
lower the swivel,
Lift rear latches up
1. Turn Power-
Mate e upside
down,
2. Unscrew the
two (2) Power-
Mate _ cover
screws.
4. To remove cover, grasp
the sides and pull out.
5. Depress tabs
on rear of
agitator cover
and rotate
forward to
release from the
Power-Mate _
base.
End Cap
Agitator
Covet
Tabs
6o Lift agitator
assembly out
and remove
worn belt.
7. Slide end
caps off to check
and clean end cap
areas° See
AGITATOR
ASSEMBLY
for
picture of complete
agitator assembly
End Cap
18
Advertisement
