Winding From The Second Spool Holder - Pfaff tiptronic 6232 Instruction Manual

W
Winding from the second spool holder
Swing the second spool holder (25) up and
place a spooi of thread with the correspon
ding unwinding-disk on it.
Hold the end of the thread firmly and press
the foot control. The winding action will stop
automatically as soon as the bobbin is full.
Cut the thread, push the bobbin to the left
and remove it.
Turn the handwheel release disk (6) fully back
again. Then turn the handwheel (5) towards
you until it snaps into place.
TIP: If the machine is already threaded, you
can easily wind thread from the second spool
holder without having to unthread the
machine.
ji1±1I
L
Threading
Place the thread into guide C and pull it
through opening B to the night under hook D
____________
(see page 16, top illustration>. Wind the thread
clockwise a few times around the bobbin.
Switch on the on/off switch
Don't forget:
17