Advertisement
1
DR 859
Winding the Bobbin
Disengage the sewing mechanism and raise the spool
pins to the vertical position.
Place a spool of thread on one of the spooi pins and
a bobbin on the bobbin winder spindle, making sure
that the key at its base enters the slot in the bobbin.
Pass the thread through the righthand thread guide,
down and around the thread retainer stud, and up to
the bobbin. Wind a few turns of thread on the bobbin
in clockwise direction. Push the bobbin to the right
and start the machine. The bobbin winder will stop
automatically when the bobbin is full. Press the bobbin to the left and
remove it from the spindle. Then tighten the stop motion knob again.
The amount of thread to be wound on the bobbin is regulated by turning
the adjusting button accordingly. Set the button at position A for the mim
mum amount of thread, or at position B for the maximum. The button can
be turned to the desired position after loosening its set screw with a
screwdriver.
A
B
9
Advertisement
